User Menu Options; Alarm Reset; Stop Alarm - Bentel Security Omnia User Manual

User menu options

Enter a valid User code PIN then press
A Welcome message will be shown, and it will be possible to select the various User menu options.
+ The Welcome message can be disabled by the installer.
Use
Press
USER MENU options:
r Alarm reset
r Stop Alarm
r View buffer
r Zones status
r Arm / Disarm partitions
r Print buffer
r Overtime request
r Auto-arm En/Dis. (Enable / Disable Auto-arming)
r Teleserv.request
r En./Dis.Teleser. (Enable / Disable Teleservice)
r En./Dis.Answer. (Enable / Disable Answering machine)
r Outs management
r Codes programm.
r Clear call queue
The default User code is 0001: only this Code is Available / Active
+
+
The Installer can program the 31 User codes to operate specific partitions, and options. The User menu will show
the User code options only.
+
The selected options will affect the partitions of the User code and keypad in use.
+ Request Denied will be signalled by an error beep, and an error message (refer to Basic Options).
n Alarm reset
Select this option to delete the zone and partition alarm memories, and force alarm signallers (connected to the alarm
outputs) into standby status.
Before stepping back to the USER MENU the following message will be shown:

Alarm reset

Use the Stop Alarm option to stop the signallers- - - - in the event of persistent Alarm
signalling after reset.
The causes of persistent alarms (e.g. faulty sensors) must be traced and dealt with
immediately.
n Stop Alarm
Select this option to force the alarm signallers (connected to the alarm outputs) into standby status.
The following message will be shown:
ATTENTION!

Stop Alarm

+
No new alarms can be generated during this phase.
Press any key to exit.
CONTROLLING THE SYSTEM VIA KEYPAD
9 0
or to scroll the Options.
to select.
D O N E!
to access the USER MENU.
<PIN> +
9