Web: Viewing And Configuring Gvrp; Gvrp Operating Notes - HP ProCurve 5300xl Series Management Manual

GVRP

GVRP Operating Notes

3-18

Web: Viewing and Configuring GVRP

To view, enable, disable, or reconfigure GVRP:
1. Click on the Configuration tab.
2. Click on
[VLAN Configuration]
To enable or disable GVRP, click on GVRP Enabled.
•
• To change the Unknown VLAN field for any port:
i. Click on
[GVRP Security]
ii. Click on
[Apply]
Unknown VLAN fields.
For web-based Help on how to use the web browser interface screen, click on
the button provided on the web browser screen.
[?]

GVRP Operating Notes

■ A dynamic VLAN must be converted to a static VLAN before it can have
an IP address.
The total number of VLANs on the switch (static and dynamic combined)
■
cannot exceed the current Maximum VLANs setting. For example, in the
factory default state, the switch supports eight VLANs. Thus, in a case
where four static VLANs are configured on the switch, the switch can
accept up to four additional VLANs in any combination of static and
dynamic. Any additional VLANs advertised to the switch will not be added
unless you first increase the Maximum VLANs setting. In the Menu inter-
face, click on
2. Switch Configuration ...
global config level of the CLI, use
Converting a dynamic VLAN to a static VLAN and then executing the write
■
memory command saves the VLAN in the startup-config file and makes it
a permanent part of the switch's VLAN configuration.
Within the same broadcast domain, a dynamic VLAN can pass through a
■
device that is not GVRP-aware. This is because a hub or a switch that is
not GVRP-ware will flood the GVRP (multicast) advertisement packets
out all ports.
■ GVRP assigns dynamic VLANs as Tagged VLANs. To configure the VLAN
as Untagged, you must first convert it to a static VLAN.
and do the following:
and make the desired changes.
to save and implement your changes to the
|
8. VLAN Menu
.
max-vlans
| . In the
1. VLAN Support