Related Manuals for SGS TJ2
Summary of Contents for SGS TJ2
- Page 1 TROLLEY JACK OWNER’S MANUAL FOR YOUR SAFETY PLEASE READ THESE INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE USE.
-
Page 2: Specification
This jack is designed for use on hard level surfaces only. Do not use on concrete substituted surfaces such as ‘tarmacadan’ etc. Do not move the vehicle while it is lifted by this trolley jack. WWW.SGS-ENGINEERING.COM PAGE 2... - Page 3 • No after market alterations must be made to this jack. • Only designated attachments and adaptors supplied by sgs engineering should be used. • Ensure minimum distance of 50cm between static objects such as doors, walls etc to allow for vehicle tilting.
-
Page 4: Inspection Before Each Use
This trolley jack should be taken out of service if it is believed to have been subjected to an abnormal load or shock. Owner/operators should be aware that repair of this trolley jack requires specialist attention in the form of suitable repair equipment and knowledge. WWW.SGS-ENGINEERING.COM PAGE 4... - Page 5 PURGING YOUR TROLLEY JACK Sometimes during transport and handling, air gets into the hydraulic system causing poor lifting performance. Before the initial operation purge any air from the system by following these steps: 1. The jack handle should be placed on the release valve and turned anti- clockwise to open the valve.
-
Page 6: Raising The Vehicle
3. Consult the vehicle owner’s manual to ascertain the location of jacking points and position the jack beneath the lifting point. 4. Raise your vehicle by closing the release valve and pumping the handle. WWW.SGS-ENGINEERING.COM PAGE 6... -
Page 7: Lowering The Vehicle
LOWERING THE VEHICLE 1. Place the handle onto the release valve and turn it slowly anti-clockwise to open the release valve. 2. The vehicle will lower. PAGE 7... - Page 8 Visually inspect for oil leaks (only a slight oil seepage is permissible). If a leak is found, take the jack out of service and consult with SGS Engineering. Annually. Check the ram oil level as follows: 1.
- Page 9 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE ACTION Jack will not lift to Low oil level Check oil level and full height refill if necessary Jack will not hold Release valve not Contact customer load closing, oil may be service: contaminated- pump (+44) 01332 576 850 valves not sealing, cylinder ram may be binding...
-
Page 10: Warranty
WARRANTY This SGS product is covered by a 24 month warranty from the initial date of purchase. This is a domestic warranty provided directly by SGS Engineering. Please keep a recipt of your pucrchase as this may be required as proof of purchase. -
Page 11: Technical Diagram
TECHNICAL DIAGRAM PAGE 11... - Page 12 Overload valve Bolt, Castor wheel valve adjusting screw Steel ball O-ring seal Lock washer Steel ball Spring Flat washer Cylinder, Pump Spring guide O-ring seal, pump cylinder overload valve Filler plug Covering Spring washer Fiber washer, Oil chamber WWW.SGS-ENGINEERING.COM PAGE 12...
- Page 13 SGS Engineering (UK) Ltd West Side Park Raynesway Derby, DE21 7AZ EC Declaration of Conformity This is an important document and should be retained MANUFACTURER’S NAME: SGS Engineering (UK) Ltd Hydraulic Trolley Jack TYPE OF EQUIPMENT: PART NUMBER: APPLICATION OF EC COUNCIL DIRECTIVES / STANDARD:...
Need help?
Do you have a question about the TJ2 and is the answer not in the manual?
Questions and answers