GOLDSTAR GPS The Rocket Install Manual
  1. Manuals
  2. Brands
  3. GOLDSTAR GPS Manuals
  4. GPS
  5. The Rocket
  6. Install manual

GOLDSTAR GPS The Rocket Install Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

The ROCKET Install Guide
Table of Contents
Standard Installation
Standard Starter Disable Installation
Starter Disable with ECM Installation
Installation Do's and Don'ts
the
Gold
Standard
in GPS tracking
TM
.....................................................................................................................
.......................................................................................
......................................................................................
........................................................................................................
Toll Free Support
877.563.0012
2
3
3
4
GLD-C-S-0710-ROCKET

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the The Rocket and is the answer not in the manual?

Questions and answers

Summary of Contents for GOLDSTAR GPS The Rocket

  • Page 1 The ROCKET Install Guide Table of Contents Standard Installation ........................Standard Starter Disable Installation ..................Starter Disable with ECM Installation ..................Installation Do’s and Don’ts ......................Gold Standard Toll Free Support in GPS tracking 877.563.0012 GLD-C-S-0710-ROCKET...

  • Page 2: Getting Started

    For customers installing the starter disable feature, please see page 3 for more instructions. The ROCKET requires constant power to operate properly. The red wire will need to be connected to a constant +12V source. This can easily be located under the dash; fuse panels are good places to start, as well as the thicker gauge wires.
  • Page 3 GREEN GREEN YELLOW - Not Used WHITE - Key ignition sense (warning buzzer) BLACK (ground) The ROCKET FUSE RED (+12V) Starter Disable with ECM Installation Background The starter disable with ECM installation needs to be performed whenever any sort of control or security module is installed between the key (ignition) and the starter.
  • Page 4 Installation Do’s and Don’ts • Ground directly to the frame • Make solid splices and insulate them well • Secure the device and all wiring • Ensure the proper light sequence before closing up the dash • Use a constant 12v power supply DON’T •...

Table of Contents