Advanced Settings; Temp Settings; Charging Settings; Charge Times - Dimplex Quantum Series Installation Manual

Advanced Settings

These settings can be used to significantly change the operation of the heater. While useful for very specific
requirements, there is a much higher risk of User error and unintended consequences of changing these settings
compared to the top-level settings menu. It is recommended that these settings are only modified by trained
professionals.
To navigate to the Advanced Settings menu, from the home screen:
Press and hold Advance and Menu buttons for 5 seconds.
Each of the following headings relate to an item in the settings menu.

Temp Settings

Temp Units (Temperature Units)
This setting defines which temperature units are displayed on the heater. The default is °C, but °F can
be set. When °F is selected, the heater will convert °C values to °F and round to the nearest number.

Charging Settings

If the output of the storage heater is not able to deliver the required heat demand throughout the day, it is
possible to force the heater to store additional energy. This will manually adjust the charge calculation to store
more electrical energy during the charging period.
This setting displays the available charge times for the Heater to store off-peak energy. It is presented like the
Timer setup screen, but without a Target Temperature or Day Selection. This allows the Installer to set up to 4
charging On and Off times.

Charge Times

This setting displays the available charge times for the Heater to store off-peak energy. It is presented like the
Timer setup screen, but without a Target Temperature or Day Selection. This allows the Installer to set up to 4
charging On and Off times.
Charge times should remain at the default settings (as shown above) for twin supply installations. This setting
should only be used in single supply installations. Values entered here always take precedent.
- 31 -
Default charge times (Standalone) are:
Period 1 00:00 - 00:00
Period 2 00:00 - 00:00
Period 3 00:00 - 00:00
Period 4 00:00 - 00:00