Technical Data - Hilti TE 60-A36 Manual

Status
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.7.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED flashes, the product is not in working order.
4 LEDs flash, the product is not in working order.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.8 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4

Technical data

Rated voltage
Weight in accordance with EPTA procedure 01
Single impact energy in accordance with EPTA procedure 05
Hammer drill bits, Ø
Breach bits, Ø
Percussion core bits, Ø
PCM diamond core bits, Ø
Drill bits for metal, Ø
Drill bits for wood, Ø
Chuck
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
8 English
Printed: 06.06.2018 | Doc-Nr: PUB / 5434431 / 000 / 00
Meaning
• The product is switched off.
• The product is working at half power.
• The product is working at full power.
Meaning
• State of charge: 75 % to 100 %
• State of charge: 50 % to 75 %
• State of charge: 25 % to 50 %
• State of charge: 10 % to 25 %
• State of charge: < 10 %
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
TE 60-A36
36 V
8.1 kg
8.1 J
12 mm ...40 mm
40 mm ...80 mm
45 mm ...100 mm
42 mm ...102 mm
10 mm ...20 mm
10 mm ...32 mm
TE­Y