Ops-Core Mesh Helmet Cover Installation

INSTALLATION CONTINUED
ATTACH BACK OF HELMET COVER
Pull the back of the Mesh Helmet Cover down. Align
both back side edges with the back side edges of the
FAST Side Rails (ARCs) as shown.
SECURE MESH HELMET COVER
Loosen the Rear Chinstrap Anchor T-Nut and slide the Rear
Fitband Tab all the way back so that the corner of the helmet
shell is exposed. Clean area with Rubbing Alcohol, then adhere
a Velcro Circle to the exposed helmet shell corner as shown.
Fold the Mesh Cover's Rear Velcro Tab over the edge of the
helmet shell and secure it to the newly placed Rear Velcro
Circle. Cut off any excess Velcro on Cover's Tab.
Push the Rear Fitband Tab up and over the Cover's
secured Velcro Tab as shown.
Repeat Steps A-C for the opposite side, then
tighten both Rear Fitband Screws.
Rear Velcro
Tab
FAST Side
Rail (ARC)
Cover
Velcro Tabs
Velcro Circle
Location
Anchor T-Nut
Rear
Fitband Tab
Rear Fitband
Tab
Rear Velcro
Tab
MESH HELMET COVER
FOR FAST HIGH CUT & SUPER HIGH CUT HELMETS
FAST HELMET CUT
HIGH CUT SUPER HIGH CUT
(FAST XP & LE) (FAST MT)
SIZE
M L XL XXL
06-16-000 REV. C