Table of Contents
Advertisement
Quick Links
North America
THANK YOU FOR PURCHASING A SELECON FIXTURE. WE HAVE DESIGNED THIS FIXTURE TO PROVIDE
YOU WITH A SUPERIOR FITTING IN PERFORMANCE, DESIGN AND ENGINEERING. WE ARE CONFIDENT
THAT IT WILL PERFORM TO YOUR EXPECTATIONS FOR MANY YEARS TO COME.
IMPORTANT NOTE:
Before discarding the packaging ensure you have the suspension bolt set, color frame, lamp base spacers
&/or the lamp.
Before operating your new luminaire please read this information to assist you in making maximum use of
your luminaire, its maintenance and care. If you would like further assistance contact your Selecon dealer
or Selecon.
LAMPING YOUR FIXTURE
Before lamping – DISCONNECT THE FIXTURE FROM THE POWER SUPPLY. Be aware also that the lamp,
fixture or integrated safety bond may still be hot, so exercise the necessary caution to avoid burns. Please
note also that these fixtures are not suitable for mounting on a normally flammable surface.
The Selecon Rama Fresnel and PC range comprises four models: the High Performance 7" Fresnel, High
Performance 7" PC, 6" Fresnel and 6" PC.
Selecon Rama Fresnel and PC with P28 Lamp Base
The Selecon Rama range with P28 lamp base is designed for use with either the BTN 750W or BTR 1000W lamp.
Selecon Rama Fresnel and PC with G22 Lamp Base
The Selecon Rama range with G22 lamp base is designed for use with the EGT 750W 1000W lamp.
To relamp:
Release the clip fastener and swing down the door.
Insert lamp taking care not to touch the quartz envelope with your fingers.
Close door and lock off the fastener.
Version 4: September 2010
RAMA FRESNEL & PC RANGE
OPERATION MANUAL
The fixture should be at least 5ft away from the nearest object it is
lighting.
© Selecon
All Rights Reserved
Advertisement
Table of Contents
Related Manuals for Selecon Rama Fresnel Series
Summary of Contents for Selecon Rama Fresnel Series
- Page 1 Performance 7” PC, 6” Fresnel and 6” PC. Selecon Rama Fresnel and PC with P28 Lamp Base The Selecon Rama range with P28 lamp base is designed for use with either the BTN 750W or BTR 1000W lamp. Selecon Rama Fresnel and PC with G22 Lamp Base The Selecon Rama range with G22 lamp base is designed for use with the EGT 750W 1000W lamp.
- Page 2 Reverse the process with a new safety chain. Replace only with the approved Safety Chains available from Selecon or your distributor. WARNING: the integrated safety chain will get very hot during use, please take care in handling when the luminaire is on.
- Page 3 This is the only maintenance task, which can be safely carried out by non-approved personnel. Refer below – Safety & Maintenance note. SAFETY & MAINTENANCE Selecon has manufactured this fixture in accordance with recognised best practices to recommended international safety standards. It is your responsibility to maintain this fixture in good and safe working condition.
- Page 4 However, the owner shall bear the cost of freight and insurance on the fixture, both ways. If Selecon does not wish to service, repair or replace the defective fixture, it shall refund the purchase price. Selecon’s sole responsibility is to repair, replace or service a fixture subject to a valid warranty claim. Under...
Need help?
Do you have a question about the Rama Fresnel Series and is the answer not in the manual?
Questions and answers