Replacing Pump's Impeller; Replacing Float Switch - Steamin Demon XL15 Repair Manual & Parts List

Replacing Pump's
Impellor
1. Unplug machine at outlet.
2. Remove engine compart-
ment cover (refer to page 2:
Removing Engine Compart-
ment Cover).
3. Remove pump (refer to page
2: Removing Discharge Pump).
4. Remove pump head plate
and pull impellor out of pump
head with needle-nose pliers
(fig 6).
5. Remove any debris (hair, lint
etc.) that may have accumulated
in pump head.
6. Insert new impellor.
RULE OF THUMB: When
pump is new, the pump head
plate is sealed with three pa-
per gaskets (fig. 6). Depend-
ing on how well your pump is
priming, you may need to re-
move one or possibly two of
these gaskets. Also, if the
pump head plate is worn, you
may need to flip it over when
you install it back on the pump
head.

Replacing Float Switch

1. Unplug machine at outlet.
2. Remove engine compartment
cover (refer to page 2: Removing
Engine Compartment Cover).
Pump Mount
Brass Fitting
Suction hose
Figure 4: Removing pump
Pump Head Plate
Pump Gaskets (3)
Bolts (4)
Figure 6: Replacing impellor
-3-
11/16" wrench
Terminal block
Figure 5
Impellor
Needle-nose pliers
Ground
wires