Warnings - HP TippingPoint Series Hardware Installation And Safety Manual

CAUTION: The equipment rack must be anchored to an unmovable support to prevent it from falling over
when one or more servers are extended in front of it on slide assemblies. The equipment rack must be
installed according to the manufacturer's instructions. You must also consider the weight of any other
device installed in the rack.
Make sure that the chassis cooling fans run continuously while the system is powered.
CAUTION: Make sure all cards are completely connected to the backplane. Improper connections can
disrupt system operation.

Warnings

Warnings tell you how to avoid physical injury to people or equipment. For people, injury includes
anything from temporary conditions, such as pain, to irreversible conditions such as death. For equipment,
injury means anything requiring repair. Warnings tell you what you should or should not do, and the
consequences of not heeding the warning.
Installation Warnings
WARNING!
Disconnect the power and network cables before servicing.
WARNING!
WARNING!
the unit. This equipment needs to be grounded to an external ground connection. Use a green and yellow
14 AWG ground wire to connect the host to earth ground during normal use. Disconnect the ground
connection only when the unit is completely powered down.
WARNING!
cards and modules. Do not directly touch the backplane with your hand or any metal tool, or you could
shock yourself.
WARNING!
edge.
WARNING!
AS/NZS 60950- 1 Service Personnel.
WARNING!
8 TippingPoint Hardware Safety and Compliance
Only trained and qualified personnel should install, replace, or service this equipment.
Read all of the installation instructions before you connect the system to its power source.
When installing the product, always make the ground connection before applying power to
On the product during this procedure, wear grounding wrist straps to avoid ESD damage to
To prevent personal injury or damage to the chassis, lift the chassis from underneath its lower
This equipment is to be installed and maintained by service personnel only as defined by
The Installation of this product must comply with local and national electrical codes.