Do you have a question about the WD2100XC and is the answer not in the manual?
Questions and answers
June
February 15, 2025
My washer/dryer will not change cycles.
2 comments:
Mr. Anderson
February 15, 2025
The Splendide WD2100XC washer/dryer may not change cycles if the door is locked or the program needs to be restarted. The ON/OFF button controls power and unlocks the door during wash and dry cycles. If the cycle is stuck, pressing and holding the START (Cancel) button can cancel a program in progress. Additionally, the DOOR LOCK LED indicates if the door is locked, which may prevent cycle changes.
This answer is automatically generated
June
February 15, 2025
@Mr. Anderson thank you. I will try this.
June
February 15, 2025
Holding the on/off button does not release the locked door.Nor does it cause a cycle change. Is there something else I should try.
1 comments:
Mr. Anderson
February 15, 2025
If the ON/OFF button does not release the locked door or change the cycle, check if the DOOR LOCK LED is rapidly flashing along with at least one other LED. This indicates an abnormality. Refer to the troubleshooting section of the manual for specific error details. If the issue persists, disconnect power to the washer at the circuit breaker or fuse box, or unplug the machine, and contact an authorized repair service company.
Cycle Description Chart, 16 Before starting a cycle, 17 Determining load sizes, 17 Setting a ‘wash’, ‘dry’ or ‘wash-to-dry’ cycle, 17 Splendide laundry tips, 18 For best results, 18 Combo laundry FAQ’s / Sample loads, 19 Care and maintenance, 20-21...
General Information As an Energy Star Partner, Splendide Division of Westland Sales has determined that Energy Star labeled models meet the Energy Star guidelines for energy efficiency. General Information This appliance was tested by UL and conforms with both Canadian and U.S.
Min. Installation Spacing Dryer Exhaust Requirements NOTE: The manufacturer reserves the right to make any improvements to its appliances without giving prior notice. Splendide 2100XC, Splendide 2100XCP lbs. Width: 23.4” (59.5 cm) Height: 33.25”-33.75” (84.5-85.7 cm) Depth: 22” (55.9 cm) Sides: 0”...
• Repair or replacement of a part should be made only by a qualified service technician to prevent personal injury or damage to the machine. Contact Splendide to locate an authorized repair service company near you. • Disconnect power to the washer at the circuit breaker or fuse box, or unplug the machine in an emergency or when servicing is required.
(all while conserving more energy and water than other brands). Enjoy your new Splendide! Read this manual Please read this manual carefully. If you need further assistance, please contact Splendide...
Installation Requirements ATTENTION! For your own protection and to prevent accidents, injury, and fire, please read the following carefully before installing the washer-dryer. • Installation and grounding must be done in accordance with local codes and by a qualified installer. Installation Instructions provided in this booklet are for the installers’...
RV or boat water damage Splendide Drain-A-Way Pan, concerns or equivalent. to make a 90” duct Splendide 90˚ offset elbow, or turn in less than 4.5” equivalent. Drainage Standpipe Diameter/Capacity - Needs a 1 ¼” minimum diameter standpipe with a minimum carry-away capacity of 7 gallons per minute.
Installing the washer-dryer Unpacking the washer-dryer • Carefully remove the packing materials with care not to damage the drain hose and power cord that are shipped installed on the machine. Check that the machine is intact. Report any damage immediately. •...
Connecting the drain hose It is possible for the water to be discharged into a sink, standpipe or drainpipe, but an air break must be available at a minimum 20” height to prevent the machine from siphoning (Fig. 6). Floor Standpipe Wall Standpipe A &...
Installing exhaust ducting IMPORTANT: This appliance should NOT be exhausted into a chimney, wall, ceiling, or any concealed space of a building. Only rigid or flexible metallic ducting should be used. • Rigid or flex metal/metallic ducting should be used. •...
A SecureFit Bracket Kit is available from Splendide to keep the unit from shifting front-to-back or side-to-side. • Test and clean the washer. Run a test load with no laundry.
Press fabrics in less time. More Rinse Cycles Most washers have only 1 rinse following each wash while your Splendide washer-dryer has up to 4. It rinses 2-3 times About your appliance after every wash (except Express Wash) and features an Extra...
Description of the control panel STATUS LED’s ON/OFF (Door Open) Button Turns power to the washer ON or OFF, unlocks the door during the wash and dry cycles. Also restarts a SILK or WOOL cycle that’s gone into Anticrease/ Soak. DOOR LOCK LED Indicates when the door is locked and when it can be safely opened:...
Description of the Option Buttons You can customize the wash by adding an OPTION or combination of options to your cycle selection. The button corresponding to the OPTION selected will remain LIT. NOTE: If you push an OPTION button and it flashes, that means the OPTION you selected is not available for that cycle.
NOTE: Splendide recommends using 1 to 2 tbsp. of a bio-friendly, or similar brand per wash load. These softeners tend to appear light in color and dissolve more quickly in less water, minimizing build-up within your machine.
Washing and drying Cycle Description Chart Cycle Selector Degree of Cycle Fabric type soil Name Cotton Heavy Duty Cycles Exception- Super ally Soiled Heavy cotton fabrics: Heavily Heavy Soiled i.e. sheets, socks, Regular Soiled towels, jeans, underwear, Lightly Express sweatshirts, etc. Soiled Cotton Permanent Press Cycles...
Before starting a cycle Always make sure, • the drum is loaded correctly (see below) • the door is closed • the ON-OFF button has been pressed and machine power is ON • laundry aids have been added to the Dispenser Drawer (see below) IMPORTANT: DO NOT attempt to open the door when the ‘Door Lock’...
When using the ‘Wool’ cycle, for best results, use a detergent that is for wool garments, taking care not to wash more than 2.2 lbs. Splendide laundry tips • Wash cycles are 30 to 96 minutes. • Dry times for average sized loads are 60 to 80 minutes •...
Combo laundry FAQ’s Is using a combination washer-dryer much different than what I’m use to? Yes, in some ways. You are washing and drying in the same drum and load sizes are smaller. Wash cycles are similar, but because combination washer-dryers are compact and operate using 115V (vs.
Care and maintenance Turning off the water or electricity supply Turn off the water supply after every wash. This will limit the wear of your appliance’s water system and also prevent leaks. Unplug your appliance when cleaning it, while on vacation and during all maintenance operations.
No lint filter to clean Your Splendide removes the lint automatically with the help of it’s self-cleaning pump, so there’s no lint filter to clean. However, it is recommended that you occasionally inspect the outside vent and dryer ducting for any lint accumulation (see below).
If the unit still enters the diagnostic mode, please record which lights are at least one flashing, as well as the model and serial number of your machine. other LED 4. Call Splendide Technical Support. Troubleshooting Possible Causes / Solution...
Incorrect wash cycle • Clothes matted to the drum after spin. • Refer to www.splendide.com for additional fabric care tips. If you need assistance Every Splendide washer-dryer comes with a Limited Warranty. Please read the Limited Warranty Statement that came with your machine for complete details.
Need help?
Do you have a question about the WD2100XC and is the answer not in the manual?
Questions and answers
My washer/dryer will not change cycles.
The Splendide WD2100XC washer/dryer may not change cycles if the door is locked or the program needs to be restarted. The ON/OFF button controls power and unlocks the door during wash and dry cycles. If the cycle is stuck, pressing and holding the START (Cancel) button can cancel a program in progress. Additionally, the DOOR LOCK LED indicates if the door is locked, which may prevent cycle changes.
This answer is automatically generated
@Mr. Anderson thank you. I will try this.
Holding the on/off button does not release the locked door.Nor does it cause a cycle change. Is there something else I should try.
If the ON/OFF button does not release the locked door or change the cycle, check if the DOOR LOCK LED is rapidly flashing along with at least one other LED. This indicates an abnormality. Refer to the troubleshooting section of the manual for specific error details. If the issue persists, disconnect power to the washer at the circuit breaker or fuse box, or unplug the machine, and contact an authorized repair service company.
This answer is automatically generated