Advertisement
Installation Procedure (How to Affi x) (continued)
Installation Procedure
The installation procedure/method is equivalent to that used for ordinary glass film.
Sticker for identifying
surface to affix to glass
Release film
1) Use, for example, protection sheets and towels
as covers to prevent other than the installation
area from getting wet.
2) Clean the glass using soapy water, a rubber
wiper, and towels.
3) Measure the glass size with a tape measure.
4) Cut the film screen to the required size using a
ruler and cutter knife.
5) Spray soapy water on the glass using a spray
bottle.
6) Spray soapy water on the adhesive surface while
peeling off the release film of the film screen.
z When the film screen to be affixed is large, the
work should be performed by at least two persons.
7) Affix the film screen to the glass.
z Take care that air bubbles do not enter between
the film screen and glass at this time.
8) Use a squeegee to push out the air bubbles and
water from the center toward the edges.
ENGLISH - 7
Advertisement
