1. Manuals
  2. Brands
  3. Aqua Cooler Manuals
  4. Water Dispenser
  5. Cascade Series
  6. Usage and care manual

Aqua Cooler Cascade Series Usage And Care Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

CasCade
series
Usage and Care
Manual
Models: CDTT
Your Partner in Cool.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cascade Series and is the answer not in the manual?

Questions and answers

Related Manuals for Aqua Cooler Cascade Series

Summary of Contents for Aqua Cooler Cascade Series

  • Page 1 CasCade series Usage and Care Manual Models: CDTT Your Partner in Cool.

  • Page 2: Product Diagram

    producT diagram Hot Water Faucet (with Child Safety Lock) Red: Hot Tank Switch Room Temperature Water Faucet Green: Power Switch Cold Water Faucet FRONT BACK Bottle Empty Heating Indicator Water Indicator Cooling Water Program Indicator Button (Compressor On) Water Bottle Reset Siphon Cap Button...

  • Page 3: Important Safety Instructions

    imporTanT SafeTy inSTrucTionS When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and injury to persons or property. Read all instructions before using any appliance. Do not let hot water touch bare skin. Do not use your water dispenser outdoors.

  • Page 4: Preparing For Use

    unpacking The WaTer cooler After unpacking the water cooler, wipe with a soft cloth. Place the machine on a hard, flat surface. Make certain the unit is level. The unit should not be close to direct sunlight or other sources of heat. It is best to place the water cooler in an area with good air circulation.

  • Page 5: Installation Procedure

    inSTallaTion procedure Make sure the water dispenser is not plugged into an electrical outlet. Open the door of the lower cabinet. Place full water bottle on floor. Remove the plastic cover over the mouth of the water bottle. Place the stainless tube inside the bottle and place the water bottle cap firmly over the mouth of the water bottle.

  • Page 6: Operation

    Over consumption of cold water in a Wait for 15 minutes while the water cools short time. and try again. System malfunction. Contact Aqua Cooler service team. Unit does not dispense cold The ventilation around the unit is Ensure sufficient ventilation space around water.

  • Page 7: Indicator Lights

    indicaTor lighTS When the indicator light is on, the unit is in the process of cooling water inside the cooler tank. When this indicator light is on, there is no water left in the water bottle and it needs to be replaced.
  • Page 8 converTing To mainS connecTed Your cooler comes ready to use a 12 L to 19 L water bottle, or it can be used with a direct water line connect and filtration system. If the inlet water pressure is above 690 kPa, a pressure regulator must be installed in front of the unit’s water inlet.
  • Page 9 condenser. At the rear of the unit, locate the water connection fitting with a coil of tubing next to the condenser. When using a Filter system, disconnect the Elbow (In-line) fitting at the mid length of the tube, and store for future use with the Bottled water feature. (Fig. C) Assemble the filter as per individual instructions.

  • Page 10: Exploded Diagram

    exploded diagram Your Partner in Cool.
  • Page 11 Spare parT liST Description Code Description Code Top Back Board SPC1 Hot Water Buttn SPC39 Change - Over Switch SPC2 Indicator Light Pcb Unit SPC40 Condenser SPC3 Screen Fixed Plate SPC41 Right Side Board SPC4 Display Window SPC42 Power Cord Protector SPC5 Sst Panel Board SPC43...
  • Page 12 Your Partner in Cool. Phone Numbers address internet Sales: 1300 278 226 U14, 2-12 Knobel Court www.aquacooler.com.au Service: 1800 278 226 Shailer Park QLD 4128 info@aquacooler.com.au m0001 This document is available digitally on our website at www.aquacooler.com.au/doc/m0001 Revision 2...

This manual is also suitable for:

Cdtt

Table of Contents