Honeywell Thor VM2 User Manual page 92
Vehicle-mounted computer with microsoft windows embedded ce 6.0
Hide thumbs
Also See for Thor VM2:
- User manual (366 pages) ,
- Reference manual (196 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
5. Route the power cable the shortest way possible removing any left-over cable. The
6. Provide mechanical support for the cable by securing it to the vehicle structure at
7. Connect the watertight connector end of the power cable to the Thor VM2 dock
8. Secure the power cable to the Thor VM2 using the
9.
10. If using the
11. Press the
12. Press the
Once installation is complete, remember to start the Thor VM2 and select the desired
Power Configuration Mode to enable Auto-On, Ignition Control or Manual Control of the
Thor VM2 boot up process.
See the
Ignition Control Wiring Diagram
Ignition wire must be connected and the Ignition Control power mode must be selected
via the
able the Thor VM2 ignition signal wire can be connected (less than 1mA over input volt-
age range) to the switched circuit to allow the Thor VM2 to power on when the vehicle is
switched on. When the vehicle is switched off, more aggressive power management set-
tings are enabled to preserve the vehicle battery charge.
80
•
Ignition Control Wiring Diagram
•
Auto-On Control Wiring Diagram
•
Manual Control Wiring Diagram
cable is rated for a maximum temperature of 105°C (221°F). Therefore, when
routing this cable it should be protected from physical damage and from surfaces
that might exceed this temperature. Cable should be protected from physical
damage from moving parts. Do not expose the cable to chemicals or oil that may
cause the wiring insulation to deteriorate. Always route the cable so that it does not
interfere with safe operation and maintenance of the vehicle.
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely.
Place Thor VM2 in the Dock
Screen Blanking
Power Switch
Power Button
Power Configuration Mode
Power Configuration Mode
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
feature, install the screen blanking box or switch.
on the back of the Thor VM2 dock.
on the front of the Thor VM2 to turn on the Thor VM2.
control panel.
control panel. When switched vehicle power is avail-
Strain Relief Cable
Clamps.
Advertisement
Table of Contents
