Relay Setup; Logging Into The Relay - GE DGP Series Instruction Manual

4.4 USING GE-LINK
4
Before shipment, the relay is set with factory default settings. These include the Unit ID, the Baud Rate, and
the Factory Passwords. The default communications parameters are:
Table 4–1: DEFAULT COMMUNICATION PARAMETERS
SETTING
UNIT ID
VIEW PASSWORD
CONTROL PASSWORD
SETTINGS PASSWORD
BAUD RATE
1. To log on to the Test unit, click on the test unit IED to highlight it. Select the Communication > Connect
Relay menu item and click on Connect.
2. When prompted by GE-Link, enter the password for the appropriate access levels (GE Modem protocol
only).
4-
6
Figure 4–1: ADDING A NEW IED
FACTORY DEFAULT
0 (GE Modem) / 1 (Modbus)
VIEW!
CTRL!
SETT!
2400
DGP Digital Generator Protection System
4 ACCEPTANCE TESTS

4.4.4 RELAY SETUP

4.4.5 LOGGING INTO THE RELAY

GE Power Management