Configuring Factorytalk Security With Logix Designer Application; Introduction; Installing The Rockwell Software Security Emulator; Enabling Security - Rockwell Automation Allen-Bradley Logix5000 Programming Manual

Introduction

Installing the
Rockwell Software
Security Emulator

Enabling security

Configuring FactoryTalk Security
with Logix Designer application
FactoryTalk Services Platform (FTSP) software is installed during the
installation of the Logix Designer application.
RSLogix 5000™ software version 19 or earlier uses the Rockwell Software
Security Emulator™ to communicate with FactoryTalk Security. Starting
with version 20, the application obtains security information directly from
the FactoryTalk Services Platform and does not require RSSecurity
Emulator.
If you are using RSLogix 5000 version 19 or earlier, follow these instructions
to install the Rockwell Software Security Emulator.
1. Click the Start button, then click All Programs, then click Rockwell
Software, then click FactoryTalk Tools, and then click RSSecurity
Emulator Install.
2. Follow the installation prompts to complete the installation.
If the Security commands are unavailable, as shown in this picture, you
must enable security for the application.
For version 20 or later of the application, if the security commands are
unavailable, you need to install FactoryTalk Services Platform. See
the FactoryTalk Services Platform software
version 20 or later, and the security commands are available, skip to step 5
below.
If you are using RSLogix 5000 version 19 or earlier, you need to use
SetSecKeys to enable security. Follow the instructions below.
Rockwell Automation Publication 1756-PM016H-EN-P - March 2015
Chapter 2
on page 15. If you are using
Installing
13