Related Manuals for Starburst Technologies SB-3770ART-DR
Summary of Contents for Starburst Technologies SB-3770ART-DR
- Page 1 INSTALLATION GUIDE Full motion recessed tv wall mount SB-3770ART-DR Support 37" to 70" Screens Max Load Capacity: 200 lbs (91 kg) VESA 500x800 compatible...
-
Page 2: Tools Needed For Assembly
WARNING • Be sure to read this entire manual thoroughly and you fully understand all the instructions and warning before attempting to begin your installation. • This product should only be installed by someone who has a basic knowledge of buiding construction,installations and fully understands these instructions. -
Page 3: Parts List
Before you b egin, make sure all parts shown are included with your product. Parts may appear slightly different than illustrated. Parts List Description pan head screw / washer M6x12 / 6x13x1.2 washer 1 8.2x2.0x16 pan head screw M5x12 pan head screw M5x25 pan head screw M6x12... - Page 4 14.5” 21.5” Determine where you want your tv mounted on your wood stud wall. Note that the center of the arm of this TV mount will represent the center of your TV. Choose the appropriate height for your viewing pleasure. The location you choose must be between two 16 in on center wood studs .
- Page 5 Mounting the Assembly Adapter Plate to screen Modify the Adapter Plate Adaptor Modify the Assembled Adapter Plate Slide the adapter brackets into Assembled adapter plate slightly. Place the Assembled Adapter Plate on the back of the display with Back of Screen one Adapter Bracket aligned with a set of vertical mounting holes.Then,slide the other Adapter Bracket in or out until it aligns Adaptor and hooks...
- Page 6 For Flat Back Screen fig C.1 fig C.2 SCREEN SCREEN SPACER SCREW SCREW AA(mount) AA(mount) Select the small,medium,large or extra large screws from the baffled .Fastener pack then attach screen brackets(AA) to screen following figure C.1 or C.2 on page 7. Attach Assembly Adapter Plate to Assembly Arm top screw 1.
- Page 7 Tilt Adjustment and cord Coves Tilt Adjustment WARNING: Before removing your display,ensure 1.Loosen Tiltlevers(Only enough to the display has a allow controlled adjustment) negative Tilt and Tilt Lever is 2. Adjust Tilt LOCKED! 3. Lock Tilt Levers(Tighten) Tighten 4. Once Tilt Levers are locked,the position of the levers can be adjusted Loosen without loosening ortightening the unit by pulling the levers outwards and then...
Need help?
Do you have a question about the SB-3770ART-DR and is the answer not in the manual?
Questions and answers