Sending Snmp Traps And Email Notifications For Events - Ruckus Wireless Virtual SmartZone Administrator's Manual

Sending SNMP Traps and Email Notifications for Events

By default, the controller saves a record of all events that occur to its database. You can configure
the controller to also send SNMP traps and email notifications for specific events whenever they
occur.
Verify that global SNMP traps are enabled to ensure that the controller can send SNMP
NOTE:
traps for alarms. For information on how to enable global SNMP traps, refer to
SNMP Notifications
NOTE:
You can also manually trigger SNMP traps without generating events using CLI. You can use
the #trigger-trap <event code> command to trigger traps for respective events with
their default attributes.
You can acquire the status of a specific client MAC address by using the query
RUCKUS-CTRL-MIB. For more information, see the SmartZone SNMP MIB Reference Guide.
Follow these steps to configure the controller to send traps and email notifications for events.
1. Go to Configuration > System.
2. On the sidebar, click Event Management.
If Event Management is not visible on the sidebar, click Network Management to expand
its submenu, which contains the Event Management link.
The Event Management page appears.
3. In the Email Notification section, select the Enable check box, and then type an email
address or email addresses in the Mail To box.
If you want to send notifications to multiple recipients, use a comma to separate the email
addresses.
4. In the Events section, go over the table and select the events for which you want to send
traps or email notifications (or both).
a) If you know the event code, event type, or description, type the full or partial text into the
search box on the upper-right hand corner of the table, and then click the magnifying glass
(search) icon.
b) If you want to select all events, click the check box before the Code table heading.
By default, the Events table displays up to 20 events per page. If you are enabling
NOTE:
SNMP traps and email notifications for 10 or more events, Ruckus Wireless recommends
changing the number of events shown per page. To do this, scroll down to the bottom of
the page, and then change the value for Show to 250 (maximum).
5. After you have selected all of the events for which you want to send traps or email notifications,
scroll up to the beginning of the Events table, and then click Enable.
A submenu appears and displays the following links:
• Enable SNMP Notification: Click this link to enable SNMP trap notifications for all selected
events.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
on page 233.
Configuring the System Settings
Configuring Network Management
Enabling Global
236