Godox X1T Quick Start Manual

For connecting the godox v860ii flash with trigger

FLASH TRIGGER QUICK START GUIDE

A quick start guide for connecting the Godox V860II flash with the Godox X1T trigger.

Hereʼs a quick video to help you get started.

ht t p s://www.yout u be.com/wat c h?v=QdqOgRuRi u o&l i s t = PLRcCi 5 SRb3EVsE4ONaFz7QOAHKl h bd4y0&i n dex=4

Turn both switches on the side of the trigger on.

channel

group

mode

The flash & trigger

Can be changed to

communicate via radio

match the settings on

waves, so these are

your camera, but not

the same channels youʼd

always necessary.

see on a walkie talkie

or something similiar.

Table of Contents

Need help?

Do you have a question about the X1T and is the answer not in the manual?

Page 1 FLASH TRIGGER QUICK START GUIDE A quick start guide for connecting the Godox V860II flash with the Godox X1T trigger. Hereʼs a quick video to help you get started. ht t p s://www.yout u be.com/wat c h?v=QdqOgRuRi u o&l i s t = PLRcCi 5 SRb3EVsE4ONaFz7QOAHKl h bd4y0&i n dex=4 Turn both switches on the side of the trigger on.
Page 2 On the flash, navigate to this screen using the recieving button. You want to see “slave” mode and the “transmitter” mode. Ensure that the channel on the flash matches the channel on the trigger. Change the channel using the channel button.
Page 3 To incorporate the Speedlight YN560IV flash: Ensure that the channel on the flash matches the channel on the trigger. Change the channel using the zoom button + the tigger mode button, and then the left right buttons. Using the tigger mode button, navigate until you see the screen below.

V860ii