Monogramming And Embroidering With Embroidery Hoop - Silvercrest SNM 33 C1 Operation And Safety Notes

Monogramming and embroidering with embroidery hoop*

* The embroidery hoop is not supplied with the
machine.
Stitch Stitch width stitch length
1~5
Attach the embroidery and darning
plate
1. Remove the presser foot and the
presser foot holder.
2. Attach the embroidery and darning plate
(o).
3. Lower the two-step presser foot lifter
(18) before starting to sew.
4. Adjust the stitch width according to the
size of lettering or design.
Preparation for monogramming and
embroidering*
1. Draw the desired lettering or design on
the right side of the fabric with the use
of a water-soluble fabric marker.
2. Stretch the fabric between the
3. Place the fabric under the needle.Lower
the two-step presser foot lifter (18).
4. Turn the hand wheel (21) towards you
to bring up the lower thread through the
fabric. Sew a few securing stitches at
the starting point.
5. Hold the hoop with thumb and
6. Coordinate the sewing speed and the
movement of hoop.
embroidery hoop as firmly as possible.
forefingers of both hands.
Sewing basics
0
US-EN 25