Fork Installation - Rock Shox BoXXer R2C2 Technical Manual

XX
bo er r2C2 TeChniCal Manual
Re-installing the fork onto the bike is the final step in servicing your Boxxer fork. Once you have installed the fork onto the bike,
you will be ready to ride!
1. Slide each upper tube through the lower crown,
leaving enough clearance to install the frame
bumpers.
2. Spray a liberal amount of isopropyl alcohol or water
on the the inner surfaces of the frame bumpers and
re-install the bumpers onto the upper tubes.
3. Gently push and twist the upper tubes through the
upper crown. with a minimum extension of 2 mm,
position both upper tubes to extend past the top of
the upper crown by an equal amount. measure the
distance from the top of the upper tube to the top of
lower crown. This distance must be
156 mm (+/ - 2 mm). Align the logo on the drive side
upper tube with the logo on the lower leg.
refer to the boXXer crown heights
diagram for proper crown height dimensions.
improper crown height placement can cause a
reduction in handling performance, travel, and/or
cause fork damage.
19
f o r K in s Ta l l aT io n
in T r od uCTi on
2 3
XX
bo er Crown heighTs
Top of upper Tube
156 MM (±2 MM)
Top of lower Crown
MiniMuM
2 MM
Top of upper Tube
To
Top of upper Crown
GEN.0000000003185 REV A