Table of Contents
Related Manuals for Aquagem iSAVER Power+1100
Summary of Contents for Aquagem iSAVER Power+1100
- Page 1 FREQUENCY INVERTER INSTALLATION & USER GUIDE Power 1100, Power 2200 Thank you for purchasing our frequency inverter. Please read the manual carefully before installation & operation and keep it for future reference after installation.
-
Page 2: Table Of Contents
CONTENTS IMPORTANT SAFETY INSTRUCTIONS ..............1 TECHNICAL DATA ....................1 BEFORE INSTALLATION ..................2 CONNECTING TO POOL PUMP ................2 SETTINGS & OPERATION ..................4 PROTECTION & ERROR CODES ................6 EXCLUSIONS ......................6 WEEE LEGISLATION ....................6 SAFETY SYMBOLS Read and keep the manual in a safe place Warning Caution: Risk of electrical shock... -
Page 3: Important Safety Instructions
1. IMPORTANT SAFETY INSTRUCTIONS To make the best use of this energy saving device and to avoid potential risk of fire, electrical shock, SERIOUS injury to people or damage to property, please read this user guide carefully before installation and keep it for future reference. This device can ONLY be used with pool pumps with permanent split capacitor motor. -
Page 4: Before Installation
3. BEFORE INSTALLATION Upon receipt of this device, check for damage to the packaging or product. DO NOT PROCEED with installation if any damage is found; contact your supplier. Do not use extension leads with the device. This can pose a danger particularly in the vicinity of a swimming pool. - Page 5 Expansion plug Screw Power plug Pump socket 12mm Screw Fig. 3 Above figure is for reference only, plug & socket may vary for different countries/regions. If you do not require a power plug for installation, wire the device as shown in Fig.4, please. Power Cable Breaker (Customer prepare)
-
Page 6: Settings & Operation
5. SETTINGS & OPERATION 5.1 Control panel Current time Power Consumption Speed in rpm Day/Night/Backwash Timer on/Timer off (Low/Med/High speed) Timer Lock/Mode Increase/Decrease On/Off 5.2 Mode selection The frequency inverter has 3 modes(speed ranges).You can either run your pump at a constant speed choosing from “M”... - Page 7 during the night, you can set up to 4 timers. Step1: Press to enter timer setting Step2: Use to set current time. Press to move cursor to the next setting. Press choose a speed range for timer 1, use Press to decide on a specific speed if required.
-
Page 8: Protection & Error Codes
5.5 Parameter setting Under OFF mode, hold for 3 seconds to enter parameter settings. Parameter Description Default setting Setting range Priming time 1 minutes 1~10min, by 1 minute increments Minimum RPM 1200rpm 1200~2000rpm, by 100rpm increments 6. PROTECTION & ERROR CODES Item Code Description...
Need help?
Do you have a question about the iSAVER Power+1100 and is the answer not in the manual?
Questions and answers