User Guide Dispense Options Chilled Ambient Contents Component/Feature Overview Operation Functions & Controls General Safety CO2 Bottle Installation NOTE: This booklet to be left with Borg & Overström appliance following installation.
Operation C O L D Connect and turn on the water All hot & non sparkling cold On sparkling models turn on supply. Then connect the tanks must be purged of air the carbonation switch on the by holding the corresponding power supply.
Functions & Controls Controls Chilled Water Sparkling Water Button Button Hot/Chilled Ambient Water Button (selected models) borg&overström Sparkling/Hot LED Hot Water Button Chilled LED Basic Settings 52˚F Cold Thermostat 39˚F Factory set to: -˚F +˚F NB: Turn clockwise to decrease water temperature The temperature of cold water can be set from 39˚F to 52˚F.
General Safety • Leave a space no less than 6 inches between the wall and dispenser. • Keep the machine away from sunlight, heat and moisture. 6 Inches Basic Troubleshooting Problem/Report Possible Cause Suggested Action No Water Dispensing Water supply turned o . Check that power supply, and all taps/ valves/ and are turned on.
CO2 Bottle Installation - Sparkling Versions Only C O L D After completing the water Attach the regulator to the Connect the assembled CO2 installation, turn on the disposable CO2 bottle, bottle and regulator to the sparkling power switch and ensuring the regulator is machine using 1/4 inch pipe.
Page 8
For full distributor service manual visit: www.youraquaessentials.com Customer services: Email: rmiller@youraquaessentials.com Call: 1 (615) 942-7867 Fax: 1 (615) 345-0500 Telephone Aqua Essentials 1416 Antioch Pike, Suite 103 (615) 942-7867 Nashville, TN 37013 Email rmiller@youraquaessentials.com www.youraquaessentials.com Verson : 121718 - 01...
Need help?
Do you have a question about the Borg & Overström B4 and is the answer not in the manual?
Questions and answers