Summary of Contents for Funcl W1
- Page 1 Instruction Manual for Real Wireless Bluetooth Headset W1 (Bilateral Conversation) Please read the instruction manual carefully when using this product...
- Page 2 Keys and interface II. Product parameters 1. Bluetooth version：V5.0 2. Support agreement：A2DP/AVRCP/HFP/HSP 3. Frequency range: 2402MHz～2408MHz 4. Transmission distance：10M 5. Earphone battery capacity：55mAh 6. Battery capacity of charging box：1000mAh 7. Duration of continuous call：3.5hours 8. Duration of playing music：3.5hours 9. Charging time of earphone：1hour 10.Charging time of charging box：2.0hours 11.Supporting system：All bluetooth functions and mobile phones 12.Charging method：Power adapter output（DC 5V 150mA）...
- Page 3 (R earphone) will flash the "red and blue light" alternately, and the auxiliary headphone indicator will slowly flash the blue light. At this point, turn on the bluetooth on mobile phone and search device "W1" to connect successfully. 3. Power off a.Automatically power off after putting the earphones into the charging box.
- Page 4 2.The earphones are marked with "L" and "R". Please wear the earphones marked with "L" on the left ear, and the earphone marked with "R" on the right ear. Then, turn the earphones to position it firmly and comfortably (as shown below). ○...
- Page 5 TWS-W1 and connect it to operate normally. 7. Connect two mobile phones; According to the pairing...
- Page 6 start up, and the left/right earphone will automatically connect to bluetooth (the last time the device is connected). 9. Restore factory setting: quickly clicking the touch key for three times in charging state can restore factory setting. VI. Instructions of earphones indicator: a.
- Page 7 IX. Attention 1. Do not remove or refit the earphones for any reason, or the earphone may break down and burn down, and the manufacturer will not guarantee the damage caused. 2. Please do not put the equipment in contact with corrosive liquid, or it will cause serious damage to the equipment.
- Page 8 3. The earphones cannot be turned on: please check if there is power in the earphones and put it into the charging box again to start up. 4. Two "W1" device names appear in the mobile phone search, delete the two bluetooth names, turn off the earphones and restart the connection.
- Page 9 FCC ID: 2ARGM-W1 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the W1 and is the answer not in the manual?
Questions and answers