Setting Up the Communications Package
This section will provide the general settings for configuring a communications
package for protocol logging with the Test Set. If you are using PROCOMM
PLUS, detailed setup information for installing or reconfiguring PROCOMM
PLUS is provided.
General Setup Parameters
•
•
•
•
•
Installing PROCOMM PLUS
The following list includes the setup information that PROCOMM PLUS version
2.01 for MS-DOS from Datastorm Technologies, Inc. will prompt you for during
installation.
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amproto.fb
Baud Rate.....115,200
Parity.................None
Data Bits..................8
Stop Bits...................1
Terminal Emulation...VT100
PROCOMM PLUS Prompt Settings
Prompt: How will you use PROCOMM PLUS?
Choose: With a Direct Connection Only
Prompt: COM Ports
Choose: Available serial port
Prompt: Baud Rates
Choose: 115200
Prompt: Communication Settings
Choose: No Parity, 8 data bits (Required for Test Set)
Prompt: TERMINAL FAMILY
Choose: VT/AMSI (Required for Test Set)
Prompt: DEFAULT TERMINAL EMULATION
VT100 (Required for Test Set)
DEFAULT DOWNLOAD PROTOCOL
XMODEM (Required for Test Set)
Chapter 11, Protocol Logging
Setting Up the Communications Package
339