Camshaft Sensor No Signal Error - Mahindra Bolero Maxitruck Plus BS III 2013 Diagnostic Manual

DIAGNOSTIC MANUAL
P0340
CAMSHAFT (SEGMENT SPEED) SENSOR
Hall Effect camshaft position sensor is mounted on the front timing cover and senses the Top dead
center (TDC) point of the # 1 cylinder in the compression stroke ,which allows the ECU to determine
when to start the injection. The trigger is mounted in the front side of the camshaft
NORMAL OPERATION

Ignition ON

During engine cranking , the output signal received from cam
shaft position sensor to ECU is within the range
DTC DETECTING CONDITIONS

Ignition ON

EMS ECU supply voltage 8-16V

While engine cranking,no valid signal from camshaft position
sensor
DTC REACTIONS

Engine check lamp continuously ON.

Engine will not start

If this failure occurs when the engine is running then engine
will keep on running
HEALING CONDITION

Ignition Off/On
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2013 Mahindra & Mahindra Ltd.
EMS

CAMSHAFT SENSOR NO SIGNAL ERROR

DTC INFORMATION
MAN-00226
MAY 2013/Rev 1
PROBABLE CAUSES OF FAILURE

Open/short cam shaft
position sensor circuit

Faulty cam shaft position
sensor.

Cam shaft mechanical
failure

Malfunctioning EMS ECU
48