Rotel RA-1572 Owner's Manual
  1. Manuals
  2. Brands
  3. Rotel Manuals
  4. Amplifier
  5. RA-1572
  6. Owner's manual

Rotel RA-1572 Owner's Manual

Hide thumbs Also See for RA-1572:
Table of Contents

Advertisement

Quick Links

See also: Owner's Manual
RA‑1572
Stereo Integrated Amplifier
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RA-1572 and is the answer not in the manual?

Questions and answers

Related Manuals for Rotel RA-1572

Summary of Contents for Rotel RA-1572

  • Page 1 RA‑1572 Stereo Integrated Amplifier Owner’s Manual...

  • Page 2: Important Safety Instructions

    Clean only with dry cloth. The unit must be connected to a power supply only of the type and Rotel products are designed to comply with Do not block any ventilation openings. Install in accordance with the voltage specified on the rear panel. (USA: 120 V/60Hz, EC: 230V/50Hz) international directives on the Restriction of manufacturer’s instructions.

  • Page 3: Table Of Contents

    About Rotel ........

  • Page 4: A Word About Watts

    If you have any questions see your authorized Rotel dealer for advice about the best cable to use with your system. The main functions of the RA-1572 are easy to install and use. If you have experience with other stereo systems, you shouldn’t find anything perplexing.

  • Page 5: Remote Control Batteries

    For the remote to operate properly, make sure both the remote a 12V turn on signal. The two 12V Trigger Outputs of the RA-1572 provide and the CD or Tuner are both in same remote code, either Code 1 or 2.

  • Page 6: Digital Signal Inputs E

    The digital signals will be decoded back panel. These connectors accept bare wire, connector lugs, or dual and played by the RA-1572. The unit is capable of decoding PCM signals banana type connectors. (except in European Community countries where up to 24 bit, 192kHz.

  • Page 7: Display 3

    , then press the up/down/left/right arrow buttons on the remote to adjust the value. The port can be configured to remain powered even when the RA-1572 NOTE: Bass and Treble changes are only available when Tone Bypass is in standby mode through the front panel setup menu (See USB POWER is disabled (see Tone Control Bypass section).

  • Page 8: Power Led Dimmer 9

    To take advantage of USB Audio Class 2.0 audio playback supporting up to 384kHz sampling rates you will need to install the Windows driver supplied on the CD included with the RA-1572. You will also need to switch This 3.5mm mini-jack receives command codes from industry-standard infrared the RA-1572 to USB Audio Class 2.0 playback mode with the following:...

  • Page 9: Settings Menu

    Most likely, you will never see this protection circuitry in action. However, • POWER OPTION: Enables the RA-1572 to be controlled via the network should a faulty condition arise, the amplifier will stop playing and will port when attached to an automation system.

  • Page 10: Troubleshooting

    Fixed Volume level to “Variable”. source, the RA-1572 monitors the digital data stream to determine if there is audio. If there is no audio detected for 10 minutes, the RA-1572 • PC-USB AUDIO CLASS: Changes supported PC-USB Audio Class of the will enter Signal Sense Standby Mode.

  • Page 11: No Sound

    Apple Inc., registered in the U.S. and other countries. Rotel reserves the right to make improvements without notice. Rotel and the Rotel Hi-Fi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.

Table of Contents