Page 2
CHARGE BEFORE USING OR STORING Before using or storing, charge your Titan solar generator until it is fully charged. IMPORTANT SAFETY INSTRUCTIONS To avoid personal injury or damage to the solar generator or any connected products, carefully read, understand, and comply with all instructions before use.
Adding Multiple Battery Packs……………………………. 8 Calibrating the Battery Meter……………………………… 8 Balancing the Batteries…………………………………….. 8 Using Your Titan Solar Generator…………………………. 9 Battery Meter………………………………………………. 10 Storage …………………………………………………………….. 11 Point Zero Energy Titan Kit Set Up Diagrams…………………….. 12-15 Troubleshooting……………………………………………………. 16-18 FAQ………………………………………………………………... 19-21 Warranty Information……………………………………………… 22...
GENERAL INFORMATION Controls, Indicators, Connections FRONT VIEW (Figure 1) A- Battery display B- Power switch- down DC only, middle off, up AC and DC C- 12V DC sockets 20Amps max, each socket, or all combined. D- 120V AC sockets 15A per set of 3 (left three combined 15A, and right 3 combined 15A max) E- Reset breaker for left 3 outlets (15A) F- Reset breaker for right 3 outlets (15A)
Page 5
SIDE VIEW (Figure 2) K– External battery port L– 12V Car Charging Port and Battery Reset Port (input voltage 10-20V DC Max charging 160 watts) M– AC Charging Ports. Max 50A per port @ 29.2V N– Solar input ports. Max charging 1,000 watts per port. Max input amps 30, max VOC (voltage open circuit) 145V O–...
Life Up to 10 years or up to 2000 cycles* Warranty 2 year limited on Titan Power Module 1 year limited on Titan Battery Pack *Maximum life span of battery based on ideal conditions. Actual life span will depend on factors such as charge rate, discharge rate, cycle...
There are three ways to charge your Titan solar generator: From solar, using an AC charger (wall charger), and from a car cigarette port charger. The Titan is capable of charging from all three sources at the same time. *It’s critical to ensure that ALL THREE SOURCES OF CHARGING COMBINED does NOT EXCEED 1000 watts PER BATTERY.
Titan solar generator will go into safety mode. During safety mode, the Titan will not turn on with the power switch. To take it out of safety mode, the battery must be charged. To do this, first turn the Titan solar generator power switch to the OFF position.
Do not open the Titan solar generator; there are no user serviceable • parts inside. INITIAL SET-UP Because of it’s design, there is a specific way to initially setup the Titan solar generator. PLEASE FOLLOW INSTRUCTIONS CAREFULLY to keep your Titan functioning properly.
SYSTEM WILL DAMAGE ONE OR MORE OF THE BATTERIES. CALIBRATING THE BATTERY METER 1. Connect the first battery by stacking the Titan Power Module on top of the battery pack, making sure the rubber feet of the generator are aligned on top of the circle indentations of the battery pack.
USING YOUR TITAN SOLAR GENERATOR After initial setup, your Titan solar generator is ready to use. The Titan solar generator has two modes of use: DC ONLY and DC/AC. These two modes can be selected using the power switch. Middle selection is OFF, down is DC ONLY, and up is DC/AC.
BATTERY METER Reading the Battery Meter The battery meter shows an image of a battery. Inside the battery gives a graphical display as the battery is used, the darker color will gradually lower until the battery is empty. It also shows the remaining battery capacity listed in amp-hours as well as a charge-discharge indicator.
Try reducing the amount of power being used via AC. STORING YOUR TITAN SOLAR GENERATOR The Titan solar generator will retain a charge for up to 5 years. However, for optimal battery life, you should use 10% of the battery once per year.
AC/DC power, or down for DC only. Battery has overheated If you have been running the Titan under a heavy load, or you are operating it in a hot environment, it may have overheated your battery. Turn off the generator and move it to a cool location and allow to cool down.
Page 19
AC power. A breaker has been The Titan Generator has tripped resettable breaker buttons for the AC outlets. If one of these have tripped, you simple need to press the button back in again.
Troubleshooting Continued… There is no DC The power switch is Turn the power switch down for power turned off DC only power, or up for DC and AC power DC fuse has blown The maximum DC current to the DC outlets is 20A. If you go over 20A, the fuse will blow.
6 battery packs. CAN I ADD EXTERNAL BATTERIES TO THE SYSTEM? Yes, the Titan is very flexible, and can connect to a 24V external batteries such as (8S) LiFePo4 and AGM deep cycle batteries. However, for lithium batteries we suggest you use ones that have a built in battery management systems (BMS).
Page 22
HOW OFTEN SHOULD I CHARGE MY TITAN SOLAR GENERATOR? The Titan solar generator will retain a charge for up to 5 years. However, for optimal battery life, you should use 10% of the battery once per year. Make sure each battery pack is charged to at least 50% capacity and the POWER SWITCH is turned to OFF before storing.
Page 23
CAN THE TITAN RUN 3000 WATTS OR ONLY 1500 WATTS? As with any system, it's only as powerful as it's weakest link. The Titan Solar Generator was designed from the ground up to be expandable, so many of the limits of the system will not be reached until other components are upgraded to match.
LIMITED WARRANTY PERIOD The warranty period for the Titan power module is two years from original purchase date. The warranty period for the Titan solar generator lithium battery packs, whether purchased as a stand alone product or in a system, is one year from the original purchase date.
Page 25
The above limited warranties DO NOT COVER shipping or labor charges associated with the inspection and testing of generators. Point Zero Energy is not liable for any loss, cost, expense, inconvenience or damage that may result from use, misuse, or inability to use this product.
Need help?
Do you have a question about the Titan and is the answer not in the manual?
Questions and answers