Heated Insoles - Denver Anseris User Manual

4 - STAND-BY MODE: Press the power bu�on on the remote to put the insoles in Stand-By
Mode. This will not turn the insoles off completely and will s�ll allow you to turn the heat on
and adjust the heat as needed.
5 - To TURN OFF the insoles, press and hold the power bu�on on the heel of the insole for 3
seconds un�l the light on the heel turns off.
6 - To CHECK THE BATTERY LEVEL of the insoles, use the remote to turn the insoles off. The
LED light will blink to indicate the remaining charge. RED (0-33%), BLUE (34-66%), GREEN
(67-100%)
SIZING YOUR HEATED INSOLES
7
-
On the underside of your heated insoles, there are different shoe sizes indicated.
Carefully cut along the line corresponding to your shoe size (European and US
Men's Sizes are referenced), or use your exis�ng insoles as a template.
TIP: Use your exis�ng insoles as a template to get a perfect fit.
Note: Do not cut below the do�ed lines as this may damage the insoles and void
the warranty.
8
- Remove the original insoles in your shoe or boot. Place
the Heated Insoles in your shoe or boot.
1
- Press the power bu�on on the heel of the insoles for 9 seconds un�l the red
LED starts blinking.
2
- Press any bu�on on the remote to program the remote to the insoles. The light
will stop blinking, indica�ng that the pairing was successful.
Note: This can also apply if you receive a new remote.
OUTREK II HEATED INSOLES
IF THE INSOLES DO NOT RESPOND TO THE REMOTE
11