Table of Contents
Advertisement
There is no sound.
• Turn VOLUME +/– clockwise (or press
VOLUME + repeatedly on the remote).
• Check the CROSS FADER slider
position (page 31).
• Check the speaker connections
(page 13).
• There is no audio output during
Recording Timer.
There is no microphone sound.
• Turn VOLUME +/– clockwise (or press
VOLUME + repeatedly on the remote)
or turn MIC LEVEL clockwise to adjust
the microphone volume.
• Make sure the microphone is connected
to the MIC jack correctly.
There is severe hum or noise.
• A TV or VCR is placed too close to the
unit. Move the unit away from the TV or
VCR.
• Move the unit away from the source of
noise.
• Connect the unit to a different wall
outlet.
• Install a noise filter (commercially
available) to the power cord.
• Turn off surrounding electrical
equipment.
The timer does not function.
• Check the timer setting and set the
correct time (page 38).
• Cancel the Sleep Timer function
(page 38).
• You cannot select the Play Timer and
the Recording Timer at the same time.
• Check the CROSS FADER slider
position (page 31).
The remote does not function.
• Remove the obstacles between the
remote and the unit.
• Move the remote closer to the unit.
• Point the remote at the unit's sensor.
• Replace the batteries (R6/size AA).
• Move the unit away from the
fluorescent light.
There is no sound output from the
headphone.
• Turn i LEVEL clockwise to adjust the
headphone volume.
• Check the headphone connection.
• Check that the audio source on the
selected channel is played back.
There is beat sound even though you
have not played back any source.
• Press BEAT ON/OFF to turn off beat
pattern.
There is acoustic feedback.
• Reduce the volume.
• Move the microphone away from the
speakers or change the direction of the
microphone.
Speakers
Sound comes from one channel or
unbalanced left and right volume.
• Place the speakers as symmetrically as
possible.
• Check that the speaker are connected
securely and correctly.
• The source being played back is
monaural.
There is no sound from the
subwoofer.
• Adjust the subwoofer level to the
appropriate level.
• Check that the subwoofer is connected
securely and correctly.
• Check that the SYSTEM CONTROL
jack on the unit is connected.
• Check that the power cord on the
subwoofer is connected and the power is
turned on.
Sound lacks bass.
• Check that the speaker's + and –
terminals are connected correctly.
l
Continued
41
GB
Advertisement
Table of Contents
