Programming The Talk Group Information For A 2016 Base - Kenwood TK-880 Programming Instructions Manual
W/ kenwood kct-19 option connector for use with pyramid communications 2012; pyramid communications 2016; pyramid communications merlin;
Hide thumbs
Also See for TK-880:
- Service manual (75 pages) ,
- Instruction manual (49 pages) ,
- Programming instructions manual (15 pages)
Table of Contents
Advertisement
Programming the Talk Group information for a 2016 Base
The 2016 base modem operates differently than the 2012/Merlin mobile unit. As the
2012/Merlin changes talk groups for d ata and voice, the 2016 requires the radio to be
only programmed with the data talk group. This makes the base TK -x80 radio in to a
stand-alone data radio. No voice is to be used on the base TK -x80 connected to the 2016.
To program the talk group data for a 2016 interface simply add one system and one group
to the radio, and do not define any talk group for data. The figure below illustrates a
typical talk group setup for a 2016 base unit.
+------------------------------------------------------------ ------------------+
¦ System No. : 1
¦------------------------------------------------------------------------------ ¦
¦
¦ Grp EncID DecID Grp -Name
¦
1
151
151
¦
2
¦
3
¦
4
¦
5
¦
6
¦
7
¦
8
¦
9
¦
10
+------------------------------------------------------------------------------ +
Single talk group operation. This talk
group is for data only
In programming the 2012/Merlin mobile data terminal, it was required that you define the
talk group as a data talk group. When programming for a 2016 base unit, data definition
should be turned off in both the F9 and F10 (System and Group Information) screens.
Use your cursor to select the talk group and press the F9 key. The figure below shows a
typical configuration of the F9 (System Data) screen.
Data System/Group
should be left blank
Trunking Mode
Call
Pwr
Data Chan
No
Hi
+------------------------------------- +
¦
System Data
¦------------------------------------- ¦
¦ System Name
¦ System Lockout
¦ Scan Weight
¦ Auto TEL Search
¦ TA Busy Ch LOut
¦ Wide/Narrow
¦ Fix ID
¦
ID
¦
Call Indicator
¦
Horn Alert
¦
Opt Signalling
¦ Block ID's
¦
Telephone
¦
TX Inhibit
¦
Decode
¦ Data System/Group
¦ Data Delay Time
+------------------------------------- +
Grp
Option
Transpond
LOut
Signal
No
No
None
Option Signal should
be set to None
¦
: [
1
]
¦
: [***]
¦
: [*]
¦
: [No ]
¦
: [No ]
¦
: [Wide
]
¦
1st
2nd
¦
: [
]
[
]
¦
: [***]
[***]
¦
: [***]
[***]
¦
: [****] [****]
¦
Start
Stop
¦
: [
-
]
¦
: [
-
]
¦
: [
-
]
¦
: [
-
]
¦
: [ 15]ms
¦
¦
¦
TA
¦
No
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
8
Hide quick links:
Advertisement
Table of Contents
