Menu Structure - Nidec Digitax HD M753 User Manual

Safety Product Mechanical
information information installation
Figure 5-5 Mode examples
1. Parameter view mode: Read write or Read only
2. Status mode: Drive OK status
If the drive is ok and the parameters are not being edited or viewed, the
upper row of the display will show one of the following:
• 'Inhibit', 'Ready' or 'Run'.
3. Status mode: Trip status
When the drive is in trip condition, the upper row of the display will
indicate that the drive has tripped and the lower row of the display will
show the trip code. For further information regarding trip codes. refer to
Table 13-4 Trip indications on page 225.
4. Status mode: Alarm status
During an 'alarm' condition the upper row of the display flashes between
the drive status (Inhibit, Ready or Run, depending on what is displayed)
and the alarm.
Do not change parameter values without careful
consideration; incorrect values may cause damage or a
safety hazard.
WARNING
NOTE
When changing the values of parameters, make a note of the new
values in case they need to be entered again.
NOTE
For new parameter-values to apply after the line power supply to the
drive is interrupted, new values must be saved. Refer to section 5.7 KI-
Remote Keypad saving parameters on page 39.
36
Electrical Getting
Basic
installation started
parameters
Running EtherCAT
Optimization
the motor interface
5.3

Menu structure

The drive parameter structure consists of menus and parameters.
The drive initially powers up so that only Menu 0 can be viewed. The up
and down arrow buttons are used to navigate between parameters and
once Pr 00.049 has been set to 'All Menus' the left and right buttons are
used to navigate between menus. For further information, refer to
section 5.9 Parameter access level and security on page 39.
Figure 5-6 Parameter navigation
* Can only be used to move between menus if all menus have
been enabled (Pr 00.049). Refer to section 5.9 Parameter
access level and security on page 39.
The menus and parameters roll over in both directions.
i.e. if the last parameter is displayed, a further press will cause the
display to rollover and show the first parameter.
When changing between menus the drive remembers which parameter
was last viewed in a particular menu and thus displays that parameter.
Figure 5-7 Menu structure
* The option module menus (S.mm.ppp) are only displayed if option
modules are installed. Where S signifies the option module slot number
and the mm.ppp signifies the menu and the parameter number of the
option module's internal menus and parameter.
SD Card Onboard Advanced
Operation PLC parameters
*
Menu 0
....MM.000....
00.050
00.049
00.048
00.047
00.046
00.005
00.004
00.003
00.002
00.001
Moves between Menus
Digitax HD M753 Control User Guide
UL listing
Diagnostics
information
*
Moves
between
parameters
Issue Number: 3