Siemens SIMATIC S7-1500 Manual page 102

Error codes
The following table shows the module-specific error codes and their meaning for parameter
data record 128 when using an incremental or pulse encoder.
Table B- 2 Error codes for parameter validation (incremental or pulse encoder)
Error code in STATUS parame-
ter (hexadecimal)
Byte 0 Byte 1 Byte 2 Byte 3
DF 80 B0 00
DF 80 B1 01
DF 80 B2 00
DF 80 E0 01
DF 80 E0 02
DF 80 E1 00
DF 80 E1 11
DF 80 E1 12
DF 80 E1 13
DF 80 E1 15
DF 80 E1 16
DF 80 E1 17
DF 80 E1 18
DF 80 E1 19
DF 80 E1 1A
DF 80 E1 1B
DF 80 E1 1C
DF 80 E1 1D
DF 80 E1 1E
DF 80 E1 20
Technology module TM PosInput 2 (6ES7551-1AB00-0AB0)
Manual, 06/2018, A5E03982218-AB
Meaning
Data record number unknown
Length of data record incorrect
Slot invalid or not accessible
Wrong version
Error in the header information
Parameter invalid: No detailed information
available
"Operating mode" parameter invalid
"Reaction to CPU STOP" parameter invalid
"Signal type" parameter invalid
"Filter frequency" parameter invalid
"Reaction to signal N" parameter invalid
"Set function of DI" parameter invalid
"Set function of DI" parameter configured the
same for DIn.0 and DIn.1.
"Edge selection" parameter invalid
•
"Gate start (edge-triggered)" configured as
•
function for DIn.m and "At rising and falling
edge"
"Gate stop (edge-triggered)" configured as
•
function for DIn.m and "At rising and falling
edge"
"Synchronization" configured as function for
•
DIn.m and "At rising and falling edge"
"Input delay" parameter invalid
"Set output" parameter invalid
"Count direction" parameter invalid
"Reset when counting limit is violated" parame-
ter invalid
"Reaction to violation of a counting limit" pa-
rameter invalid
"Reaction to gate start" parameter invalid
Parameter data record
B.2 Parameter validation error
Remedy
Enter valid number for data record.
Enter valid value for data record length.
Check whether module is inserted or removed.
•
Check assigned values for parameters of the
•
WRREC instruction.
Check byte 0.
•
Enter valid values.
•
Check byte 1.
•
Correct the length of the parameter blocks.
•
Check all parameter values.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter different parameter values for DIn.0 and DIn.1.
Enter valid parameter value.
•
Configure "Gate start (edge-triggered)" as function
•
for DIn.m only together with "At rising edge" or "At
falling edge"
Configure "Gate stop (edge-triggered)" as function
•
for DIn.m only together with "At rising edge" or "At
falling edge"
Configure "Synchronization" as function for DIn.m
•
only together with "At rising edge" or "At falling
edge"
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
Enter valid parameter value.
101