Commissioning - Sulzer ABS RW 400 Installation And Operating Instructions Manual

Electronic amplifier for 50/60 Hz
110 - 230 V AC (CSA) (Part No.: 1 690 7010)
18 - 36 V DC (CSA) (Part No.: 1 690 7011)
ATTENTION Maximum relay contact loading: 2 Ampere
6

Commissioning

The safety instructions in the previous sections must be observed!
Before commissioning, the unit should be checked and a functional test carried out. Particular attention should
be paid to the following:
•
Have the electrical connections been carried out in accordance with regulations?
•
Have the thermal sensors/limiters been connected?
•
Is the seal monitoring device (where fitted) correctly installed?
•
Is the motor overload switch correctly set?
•
Have the power and control circuit cables been correctly fitted?
•
Has the motor connection cable been laid in such a manner that it cannot be caught up by the rotating body?
•
Has the minimum submergence level been observed? (See Section 1.7 Dimensions and weights).
36
Connect terminal 3
to ground or housing
of the RW/RCP
Figure 30. Electronic amplifier with collective signalling
Power Supply
CA 461
3 4 5 6
Output
Input
Leakage