Table of Contents
Advertisement
MSDD18-Li-2
>
Slide the battery pack (8) into the charger base (11) until it locks in place (Fig. 6).
>
Connect the charger (12) to the power supply. The indicator light (10) lights in red
when battery is charging and green when charging is finished.
>
After charging finished, disconnect the charger (12) from power supply and remove
battery pack (8) from the charger base (11) by pressing the release button (9) and
pulling out the battery pack (8) (Fig. 7).
Fig. 6
10
11
11
9
8
8
Before you start
Fig. 7
21
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MSDD18-Li-2 and is the answer not in the manual?
Questions and answers
Looking for a charger for the drill
The Mac Allister MSDD18-Li-2 drill comes with a charger included in the package. If you need a replacement or an additional charger, you may check online marketplaces such as Amazon or specialized tool retailers that sell Mac Allister products.
This answer is automatically generated
how do I release a chuck that has jammed up?
To release a jammed chuck on a MacAllister MSDD18-Li-2, turn the chuck sleeve anticlockwise until the chuck jaws open wide enough to release the bit. If the chuck is stuck, ensure the tool is off and battery is removed for safety, then try gripping the chuck sleeve firmly and turning it with more force. If it remains jammed, inspect for debris or damage and clear any obstruction.
This answer is automatically generated