Sunsdr2 Wlan - Unit Setting In Ap Client Mode - Expert Electronics DUC/DDC SDR Series Quick Start Manual

Expert Electronics
7. SunSDR2 WLAN – unit setting in AP
Client mode
1) Set transceiver IP-address in access point local net
range.
2) Connect to transceiver SunSDR2 via WiFi.
3) Enter WLAN-unit settings
internet browser. Login: admin, password: admin.
4) In Operation Mode menu tick off AP Client and
push Save (View figure 7.1)
Figure 7.1 - AP Client mode installation
5) If everything is done correctly there will be a window
as it is shown in figure 7.2. Wait till the countdown
finishes.
Рисунок 7.2 – Information window about successful
setting change
6) In Wireless settings -> WiFi Multi Bridge menu tick
off Multi-Bridge Mode and in the channel stage drop
down списке list set AutoSelect (View figure 7.3).
Then push Search AP (access point search).
DUC/DDC SDR Transceivers Series
http://192.168.16.254 via
Figure 7.3 – AP-Client mode setting
7) In the appeared window choose access point
required and save Encryption and Authentication
parameter. For our example (View figure 7.4) EE
access point is chosen with the following parameters:
Encryption: AES
Authentication: WPA-PSK
Figure 7.4 – Access point choosing
8) Then in AP Client Feature window set additional
Encryption and Authentication parameters for
chosen access point. In Pass Phrase field enter net
password. (View figure 7.5)
Figure 7.5 – Access point choosing
Note: Password 12345678, shown in figure above is
given as an example. It can differ.
12