ION Job Rocker Max Quick Start Manual

ION Job Rocker Max Quick Start Manual

Hide thumbs Also See for Job Rocker Max:

Advertisement

Quick Links

Quickstart Guide (English)
Introduction

Box Contents

Job Rocker Max
Power Cable (Heavy Duty IEC)
Power Cable (12 VDC)
Support
For the latest information about this product (system requirements, compatibility information, etc.)
and product registration, visit ionaudio.com.

Rechargeable Batteries

Rechargeable lead-acid batteries are the same type used in automobiles. As with your car battery,
how you use this battery has a significant impact on its lifespan. With proper use and treatment, a
lead-acid battery can last for years. Here are some recommendations for getting the longest life from
the internal battery.

General Usage

Fully charge the battery before using it.
Charge the battery completely after each use.
For best product longevity, do not store at exceedingly hot (greater than 90 °F /

Storage

32 °C) or exceedingly cold (less than 32 °F / 0 °C) temperatures.
It is acceptable to leave your sound system plugged in. This will not overcharge
the battery.
If you leave the battery level low and do not charge it for 6 months, it may
permanently lose capacity.
If the battery fails to charge, check your fuse near the power cable input. If your fuse

Repair

is intact and it still will not charge, contact ION Audio at ionaudio.com.

Disposal

Bring the unit to a recycling center or dispose of in accordance with local
ordinances.
Important!
!
Extension Cord Warnings:
Keep all electrical cords in good condition. Do not use worn, bare, or frayed cords, which can
cause electrical shock when Job Rocker Max is connected to wall power.
If you must use an extension cord, use only grounded extension cords that are rated for outdoor
use and equipment with a third-wire ground.
Avoid using excessively long extension cords, which can cause voltage drops, causing the cord
to overheat.
When using long extension cords with Job Rocker Max, use a heavier cord with a larger wire size
to reduce the voltage drop (the longer or thinner the cord, the greater the voltage drop).
The AC outlets are a pass-through from the power cable receptacle. Job Rocker Max does not
include surge absorption, an internal circuit breaker, or fuses for the outlets.
North America: Do not use Job Rocker Max with an IEC input cable rated for less than 15 A.
EU: Do not use Job Rocker Max with an IEC input cable rated for less than 10 A.
1/8" (3.5 mm) Stereo Audio Cable
Quickstart Guide
Safety & Warranty Manual
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Job Rocker Max and is the answer not in the manual?

Questions and answers

Summary of Contents for ION Job Rocker Max

  • Page 1 North America: Do not use Job Rocker Max with an IEC input cable rated for less than 15 A. EU: Do not use Job Rocker Max with an IEC input cable rated for less than 10 A.
  • Page 2: Quick Setup

    Please do not place Job Rocker Max in standing water. • Please do not connect the power cable to Job Rocker Max in a wet environment. Make sure the power input, power cable, and power outlet are all completely dry before making any connections.
  • Page 3 • Power Indicator: The power indicator (radio display decimal point) will be lit when Job Rocker Max is powered on. The power indicator will not be lit when Job Rocker Max is powered off. 9. Master Volume Control: This adjusts the speaker’s main mix volume, which includes the Microphone Input, Auxiliary Input, Radio, and the audio of a paired Bluetooth device.
  • Page 4 Note: The next time you approach Job Rocker Max with your Bluetooth device, it will automatically re-connect. 4. If your Bluetooth device is not able to connect to Job Rocker Max, press the Bluetooth button on Job Rocker Max to break previous Bluetooth connections and reset the Bluetooth module.
  • Page 5: Troubleshooting

    If the AC Outlet is not working: Make sure Job Rocker Max is connected to wall power. If Job Rocker Max is not charging: Make sure the fuse is not blown. If it is, replace the fuse with one of the same rating.

Table of Contents

Save PDF