Initial Setup; G20; Figure 8. Connecting The G20 - Motorola F3030A Developer's Manual

Developer Board and Interfaces Description

INITIAL SETUP

3.3
This section describes the initial procedure for setting up the g20 Developer Board for testing and evaluating of the g20. The
tasks in this section need to be performed only once, before the first time you use the g20 Developer's Kit. After performing the
initial setup, you can modify the default settings or use different peripheral devices, as described in "Configuration" on page 14.
Perform the steps in this section in sequence.
Before starting, remove the cover of the Developer Board. The cover simply slides up off the board, and does not require the
removal of any screws or clips. After setting up the Developer Board, you can place the cover back on the Developer Board by
simply pushing it gently back into place. Make sure the cover is aligned properly with the external connectors on the side of the
board.
3.3.1

g20

The Developer Board works with all versions of the g20. There are four versions of the g20:
• European version
• European version with USB driver
• North American version
• North American version with USB driver
Connect the g20 to the Developer Board by performing the following steps:
• Place the g20 into the area on the Developer Board marked by a white rectangle, and push the g20 70-pin connector down
into the UUT 70-pin connector (P1). The two screw holes on the g20 should be aligned with the g20 spacers (M2 and M3).
• Fasten the g20 to the Developer Board using the two M2 screws provided with the kit.
Internal Antenna
g20
Connector
RF Cable
g20 MMCX RF External Antenna
Screws Connector Cable Connector

Figure 8. Connecting the g20

98-08901C67-O 11