Connect A Computer To The Laser Cutter - Dremel DIGILAB LC40 Operating/Safety Instructions Manual

Connect a Computer to the Laser Cutter

For a hardwire connection:
1. Connect the Ethernet Cord to the laser
cutter (Fig. 25) and the computer.
2. Open an internet browser window on
the computer.
3. Type in the "IP" number displayed at
the bottom of the laser cutter's LCD
screen into the browser's URL bar.
For a wireless connection:
1. Select Network on the laser cutter's
LCD screen, then select Wireless from
the Network menu. (Fig. 26)
2. Select a network from the list of
avaliable networks,
password to connect the laser cutter.
3. Open an internet browser window on
the computer.
4. Type in the "IP" number displayed at
the bottom of the laser cutter's LCD
screen into the browser's URL bar.
Static IP: Connect to the network by
assigning a persistent IP address that is
assigned for the machine. This address
will be maintained permanently and will
not change if the machine is rebooted.
TIP: If the Dremel LC40 Control Software is
taking a while to load, or not working
properly try refreshing the browser to
reload the software.
SETUP
Ethernet
then enter
ig. 25
Port
"IP" Number
ig. 26
59