Philips PM 5508 Operating Manual page 19

22
Set control "RF OUTPUT" to "10 mV".
Depress switch "COLOUR BAR" and set switch "SOUND CARRIER" to
position "MOD."
Note:
With the exception of the colour settings, the tuning, etc., of the black/white
receiver to the generator is identical to the described procedure for colour
receivers. In this case, however, use the "CHECKERBOARD"-pattern.
Tune '`) the generator to the channel to which the receiver is adjusted (the
receiver should not be tuned to one of the local transmitters). As the
generator produces a double sideband RF signal, be sure to tune to the
correct sideband (the one that is highest in frequency), i.e. first set the
generator to a channel thas is lower than the one to which the receiver is
adjusted and then tune the generator to the receiver. The first sideband
"encountered", is the correct one.
The receiver can also be tuned to the channel setting of the generator. In
that case the receiver should first be set to a higher channel than the
generator, etc.
Carry out the fine tuning adjustments so that the picture on the receiver
contains colour, while at the same time there is no "sound in the picture".
Set the generator to the "GREYSCALE" pattern.
Adjust controls "BRIGHTNESS" and "CONTRAST" of the receiver to
obtain correct settings, i.e. the left vertical bar should be white and the
right one should be black, while the bars in between should show six
grey level steps increasing in darkness from left to right.
Set the generator to the "COLOUR BAR" pattern.
— Adjust control "SATURATION" of the receiver to obtain the correct
setting, i.e.: first turn it fully anticlockwise and increase the saturation
until the green and the blue dots in the red bar just disappear.
— The "customer-controls" of the receiver then are properly adjusted.
') The push-buttons for channel selecting can be pre-set to any channel within the range of the
generator. To change a presetting, turn the button while it is depressed. The dial pointer wil l
indicate the selected channel.