Replacement Of Ropes - Insportline Tower 200 User Manual

REPLACEMENT OF ROPES

To replace ropes, you need 6mm Allen key and flat open 13mm French spanner. First put the tower on
the floor. Ask other for help.
•
While the door is closed, grasp the upper pulley and tilt them back until the grooves are
loosen.
•
Move the pulleys to the lowest position on the frame and hook the tabs in place. This will result
in a greater opening of the power ropes.
•
Disconnect the middle strap and open the door.
•
Remove the bottom brackets from the bottom edge of the door. Be careful not to remove the
top brackets.
•
Pull out the top pole of the Tower and pull it out of the door. You may need a ladder.
•
WARNING: Be careful that the top frame does not fall on you as you remove the Tower from
the door. Hold the top of the frame with your hands.
Grasp the top of the frame and lift it toward the
top of the door. Slide the two frame mounts over
the top edge of the door and fasten it. You may
need a ladder. Slide the bottom frame under the
door that the frame is in line with the door frame.
Check that the frame is well centered.
As soon as you attach the tower the to the door,
slide the upper and lower frame mounts into the
center of the door. Close the door and then move
the rollers upwards until the power ropes are
firmly pulled. Check that the loops on the rollers
are in the holes.
For a better stability of the Tower, attach a black
strap between the top and the bottom part of the
frame and tighten it firmly (Note: When the Tower
frame detours from the door when exercising,
move the pulleys higher).
Hand grips and/or ankle straps are connected to
the ropes.
4