Sony DMX-P01 Operating Instructions Manual page 10

Location and Function of Parts and Controls
When M-S is selected on the 5.
CH LINK/M-S sub-menu; The
unit is in M-S mode.
Select this position for M-S
decoding when an M-S
microphone is used.
Connect channel 1 and channel 3
to the M side and channel 2 and
channel 4 to the S side. In such a
case, the input level control of the
CH-1 and CH-3 act as an input
level control and the input level
controls of the CH-2 and CH-4 act
as a phase control. Turning the
phase control to the right provides
an expansive feeling.
When the switch is set to OFF:
Controls and switches act as those
of each channel, independently.
2 Digital function section
1 LIGHT switch
2 SLATE switch
6 Slate microphone
5 ADJUST knob
4 FUNCTION switch
1 LIGHT switch
Turns the light of the LCD on or off.
10
3 LCD
2 SLATE switch
Only activates when the
4 FUNCTION switch is set to
SLATE. Turns the slate function on or
off. The slate function allows you to
record the scene number or take
number along with the sound at the
beginning of a recording for each cut,
or adjust the level using a 1-kHz
reference signal when recording using
a camcorder or recorder.
MIC: Outputs the sound to all of
output connectors from the built-in
condenser microphone.
1 kHz: Outputs a 1-kHz reference
signal to all of the output
connectors.
OFF: The slate function is disabled.
To output the voice from the
microphone or a 1-kHz reference
signal
1
Turn the L/R MASTER volume
control toward the right to
increase the volume.
2
Set the SLATE switch to either
MIC or 1 kHz.
3
Set the FUNCTION switch to
SLATE.
4
Push the ADJUST knob.
Output of the voice from the
microphone or a 1 kHz. reference
signal depends on how you press
the ADJUST knob.
When you press and hold the
ADJUST knob:
The sound or signal is output
while this knob is being pressed
when you release the knob, output
ceases.