Item
Status (read-only)
Transport IP
UDP Port
Pause
Remove
Audio Streams
Name
Status (read-only)
Transport IP
UDP Port
Pause
Remove
a.
When the sender is first enabled, the streams are named using the nomenclature: systemdevicename.sendername.video.
NEWT-IPX User Guide (v4.0)
Table 17.17 Senders — Active Streams Tab
Parameters
OK (Green)
Alarm Suppressed (Green)
Apply Changes (Yellow)
PTP Unstable, try again
(Red)
Param Out of Range (Red)
SDI Not Present (Red)
Marked for Removal (Red)
#.#.#.#
#
xx.yy
Reports the audio activity of the session
#.#.#.#
#
Description
The sender streams are operating correctly without
errors
An alarm condition is present, but the alarm is
disabled on the Alarm Enable tab
One or more settings were changed on the Setup
Streams tab. You must click Apply to update the
settings on the NEWT-IPX.
The NEWT-IPX is unable to obtain a stable clock
source. Sessions cannot be created until this
condition is fixed.
It is recommended to navigate to the Advanced >
Timing > PTP tab to check the status of the PTP
and update the Configuration settings.
One of the following is occurring:
• a sender was configured with an invalid setting.
• two senders with the same network source were
created. The NEWT-IPX can only subscribe to a
stream once.
A valid SDI signal is not detected on the specified
SDI BNC of the NEWT-IPX
The user has disabled the sender but has not
clicked the
button yet
Apply
Specifies the IP Address for the video session
Indicates the port associated with the IP address
and the communication protocol for the video
essence
The session is paused (not active)
The sessions is stopped
Provides a unique identifier for the audio channels
available on the specified SDI input where:
• xx represents the name of the card as defined in
the Advanced > Senders > Setup Streams tab.
• yy represents the name of the SDI input signal as
defined in the Name field
Specifies the IP Address for the audio session
Indicates the port associated with the IP address
and the communication protocol for the audio
essence
The session is paused (not active)
The sessions is stopped
DashBoard Interface Overview • 81
Need help?
Do you have a question about the NEWT-IPX and is the answer not in the manual?
Questions and answers