Table of Contents
Advertisement
ALARM SET:
To set or reset the alarm time:
In Standby mode, press and holding the AL. SET (Alarm Set) Button on the unit, alarm
time will appear on the display and blinking. Then:
Press the HOUR (Set) Button on the unit to set hour.
(Make sure the PM Indicator appearing on the display if the alarm time is PM
and AM Indicator appearing on the display if the alarm time is AM).
Press the MIN (Minute Set) Button on the unit to set minute.
When finished settings, release the AL. SET Button to save the settings and
exit. The actual time will appear on the display.
Press the AL. ON/OFF (Alarm On/Off) Button to activate alarm. The " "
Indicator will appear on the display.
To set or reset the wake up mode:
In alarm on mode, press and holding the AL. SET Button, alarm time will appear on
the display and blinking. Press the MUSIC/BUZZER Button at the same time
repeatedly to set or reset the wake up mode as desired. The correspondent
indicator(s) will appear on the display with your selection (see list below):
: Wake up by Buzzer
+ CD : Wake up by CD
+ ♪ : Wake up by Radio
Notes:
1.
After setting, press the AL. SET Button to read the Alarm time.
2.
Alarm will not operation when the unit is in power on mode.
3.
If radio wake up mode was selected, received the desired radio station as
previous procedure and also set the desired volume level before activate alarm.
Otherwise, when Alarm goes off, no sound output from the speaker or sound weak.
4.
If CD wake up mode was selected, make sure you were placed the desired CD
disc in the unit and sound level was set to suitable level. Otherwise, when Alarm
goes off, no sound output from the speaker or sound weak.
Shut off alarm:
When alarm goes off, press the AL.ON/OFF Button on the unit once. Alarm will
turn on again on next day.
To turn off alarm completely (alarm will not turn on next day), press the AL.
ON/OFF Button repeatedly until all the correspondence alarm indicators
disappear on the display.
14
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MM435 and is the answer not in the manual?
Questions and answers
no sound when playing cd. Sound with radio
There are several possible reasons why there is no sound when playing a CD on the Magnavox MM435, but sound works with the radio:
1. Volume Set to Minimum – The unit’s volume may be too low. Increase the volume by turning the volume control knob clockwise.
2. Aux Cable Plugged In – If an auxiliary cable is connected to the LINE IN jack, other functions like CD, Bluetooth, and radio are automatically cut off. Unplug the cable from the LINE IN jack.
3. CD Mode Not Selected – Ensure the unit is in CD mode. The “Cd” indicator should appear on the display.
4. CD Not Properly Inserted – Check if the CD is placed correctly with the label side facing up.
5. CD Not Recognized – Wait for the total number of tracks to appear on the display before pressing the play button.
If the issue continues, check if the CD is damaged or try another disc.
This answer is automatically generated