RTS DKP-3016 Quick Start Quide

Included:

• DKP-3016 Desktop Unit
OR
DKP-3016 Wallmount Unit
• 3-pan head wood screw, M5 x 25
• RTS Additonal Website Information
• Safety Instructions
• LIT Quick Start Guide F / DKP-3016
• Notice, Open Source

Requirements:

• AZedit V 5.0.0 or later
• IPedit V 3.2.0 or later
• MCII-e V 3.2.0 or later
• AIO-16 V 1.6.0 or later
• FWUT V 3.3.0 or later
• DNS-SD V 3.3.0 or later
• OMI V 5.2.0 or later

Installation

To install the DKP-3016, do the following:
1. On the rear panel of the DKP-3016, plug the AC power cord (A) into the power connector on the back panel of the unit.
IMPORTANT: Only one matrix connection may be active at a time.
2. Connect a RJ-12, RJ-45 (USOC or 568B) or Ethercon cable (B) with RTS cabling to the J8 FRAME connector on the rear
panel.
OR
Connect an CAT-5e cable (C) to J11 ETHERNET connector on the rear panel.
NOTE: For OMNEO channel setup, see the DKP-3016 User Manual.
Once the unit is cabled, plug the other end of AC power cord into the wall outlet or power strip.
3.
Quick Start Guide
DKP-3016 Keypanel