Zero Return Operation - mori seiki ZL-153S Operation Manual

6-1

Zero Return Operation

In manual operation, each axis is returned to the machine zero point at the set rapid traverse rate.
Zero return operation must be carried out in the following cases:
1. After the power is turned on
2. Before setting the tool offset data for newly mounted tools
3. After reseting an alarm state
4. After changing the machine lock function setting from "valid" to "invalid"
WARNING
DOOR INTERLOCK
NORMAL
PANEL
ON
OFF
HEAD CHANGE
1
The machine zero point varies depending on the machine model and specifications.
For details, refer to the DRAWINGS published separately.
Never stand near the moving parts of the machine during a zero return
operation since each axis is returned to the zero point at the rapid traverse
rate.
Before starting a zero return operation, always make sure that no one is
standing near the moving parts and that the moving parts can be fed to the
zero point without interference.
Failure to observe these warnings could result in accidents involving
serious injuries or damage to the machine: operators or personnel near
the machine could be crushed by the moving parts of the machine, and the
turret could strike obstacles.
RELEASE
PANEL
/EDIT
2
1) Place the DOOR INTERLOCK key-switch in the
NORMAL position.
2) Close the front door.
3) Place the PANEL key-switch in one of the positions
indicated below.
(ON)
4) Press the HEAD CHANGE switch
(head 2) to select the required turret.
MANUAL OPERATION
(PANEL/EDIT)
(head 1) or
B-19