Summary of Contents for Blomberg BFP200-27
- Page 1 A Bloomberg Professional Service Offering 27" FLAT PANEL S-SERIES Technical Information...
-
Page 2: Important Precautions
27" FLAT PANEL S-SERIES IMPORTANT PRECAUTIONS - Spray water onto a soft cloth 2 to 4 times and use it to clean the front frame; wipe in one direction only. - Too much moisture may cause staining. ASSEMBLING & PREPARING Accessories Included Display Port Cable Display Port Cable... -
Page 3: Moving And Lifting The Monitor
MOVING & LIFTING THE MONITOR - When holding the monitor, the screen should face away from you to prevent it being scratched. Adjusting the Stand Height 1) Place the monitor mounted on the stand base in an upright position. 2) Pull out the locking pin at the bottom rear of the stand body. -
Page 4: Using The Monitor
Pivot Feature The pivot feature allows the monitor to rotate 90º clockwise. Note – To avoid scratching the stand base, make sure that when rotating the monitor using the pivot feature, the stand does not make contact with the monitor. Note –... -
Page 5: Specifications
SPECIFICATIONS Model Number – BFP200-27 DISPLAY Screen Type 27" class (27.0" diagonal) TFT (Thin Film Transistor) LCD Liquid Crystal Display) Screen. Diagonal length of the screen: 68.47 cm Pixel Pitch 0.1554mm x 0.1554mm Maximum Resolution 3840 x 2160 @ 60Hz... -
Page 6: Fcc Compliance Statement
FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply within the limits of a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.