Models Numbers; Models-At-A-Glance Examples - Honeywell Experion PKS Specifications And Technical Data

EP03-300-200
Release 200

Models Numbers

Models-at-a-Glance Examples

Redundant Controller Configuration (FTE Supervisory Network)
TC - PRS021 -- C200
Control Processor
TC-FTEB01
FTE Bridge
TC - FPCXX2 --
120/240 VAC
Power Supply
to
Chassis
The above example is meant to illustrate typical component model numbers necessary for a FTE
based system with a redundant Controller on a FTE Supervisory Network (see following pages for a
Redundant ControlNet example and an Ethernet Supervisory Network Configuration example). A power
supply or a redundant power supply chassis adapter always attaches to the left-end of a chassis and
does not use any chassis slots.
The Supervisory FTE Network is a physically separate network from the I/O ControlNet (both shown).
This Supervisory network carries supervisory messages between the Experion PKS Server and
Controllers as well as peer-to-peer messages between controllers. The I/O ControlNet carries messages
between controllers and IOMs. Note that a ControlNet Tap consists of two BNC connectors for trunk
cable connection, an integral 1-meter drop cable, and a BNC connector for ControlNet Interface (CNI)
connection. Several physical models are available to accommodate different mounting layouts. FTE is
not supported as IO network.
The "A" and "B" FTE network cables connect to their own Ethernet switch, which is part of the overall
FTE switch tree. See the Fault Tolerant Ethernet (FTE) Specification and Technical Data, EP03-500-110
for more information.
Other Experion PKS operator stations connect to Experion PKS via the same FTE network.
Experion PKS CEE-based Controller Specifications and Models
TC - CCR013 -- CNI to
TC-FXX072 -- 7-slot rack
connect to I/O racks
TC-PRR021 --
Redundancy
Module
GN-KRRxx1 -- Redundancy
Cable (Fiber Optic)
ControlNet Cable -- I/O Comm
NO IOMs PERMITTED IN CONTROLLER
NO IOMs PERMITTED IN CONTROLLER
CHASSIS FOR REDUNDANT
CHASSIS FOR
CONFIGURATION!!
CONFIGURATION!!
(IOLIM and FIM are exceptions)
33
December, 2003
Version 1.0
Redundant Chassis
Identical Configuration
(module-for- module)
FTE Ethernet
to
Server