Vehicle Side Wiring Diagram - Meyer EZ Build E-58H 41150 Assembly And Installation Manual

43
44
31
White
"A"
Light
Adapter
"B" Harness
Power/Ground
Park &Turn
G. Run Universal Truck Side Harness (49) through a hole in grille and into the engine
compartment. Sandwich vehicle grill between Plug Bracket (33) and
Plate (34) using Bolt H 5/16-18 x 3" (38), 5/16 Lockwasher (36) and
5/16-18 Finish nut (37). Secure Universal Truck Side Harness (49) to
Plug Bracket (33) using Bolt H 5/16-18 x 1" (36), 5/16 Lockwasher (36)
and 5/16-18 Finish nut (37).
Secure Universal Truck Side Harness (49) from any hot
/ moving parts with tie wraps as needed.
H. Drill a 1-1/4" Diameter Hole thru firewall to install split bushing (45) and
extend the harness into the cab of the vehicle. Fused lead from Universal
Truck Side Harness (49) must be attached to terminal in fuse panel that is
activated only when the ignition key is "on. "
I. Install Motor Solenoid (43) to metal surface in engine compart-
ment using Self Tapping Screws (44). (Solenoid must be grounded
to operate). Attach Red Power Cable (49) to a large terminal on
Motor Solenoid (43). Attach Black Ground Cable (49) to negative
(-) terminal of battery. Attach Red Power Cable (31) to positive (+) terminal of
battery and remaining large terminal on Motor Solenoid (43). Attach small
white wire from harness (49) to small terminal (S) on Motor Solenoid (43).
Attach small Black/white stripe wire from harness (49) to small terminal (I)
(ground) on Motor Solenoid (43) Attach Blue wire to a reverse signal on
the vehicle. The blue wire is sensing when the vehicle is in reverse in order
to operate HFP (Hands Free Plowing).
15059 Diode packed in Control-
(S) terminal white wire
(I) terminal black wire w/white stripe

Vehicle Side Wiring Diagram

49
Red
45
"A" "B"
Black
Black Ground
"C" Harness
To Plow Light
Orange to "B"
harness of light modules
48
29
"C"
Blue (Reverse
Signal)
J. Add Meyer M-1 Hydraulic Fluid Part No. 15134 to reservoir and bleed the
Angle Cylinders, proceed as follows:
a. Remove Fill Plug from reservoir to add fluid during charging.
b. Operate the Angle cylinders (1) until they are filled with Meyer M-1
Hydraulic Fluid and are not spongy.
c. Top off the unit to the fill line on the reservoir with Meyer M-1 Hydraulic
Fluid.
NOTE: Proper fluid level is 1" below the fill plug on the E-58H. It must be checked
with the lift cylinder fully retracted.
E-58H Fill Plug (fluid
level is 1" below plug)
(6)
38
36
37
49
33
37
36
35
Hydraulic Solenoid Color Code:
OPERATION - SOLENOID COMBINATION
RAISE - Motor Solenoid + "B" Solenoid
LOWER - "A" Solenoid Only
LEFT ANGLE - Motor Solenoid Only
RIGHT ANGLE - Motor Solenoid + "C" Solenoid
COIL COLOR CODE
MOTOR SOLENOID - WHITE WIRE
"A" - BLACK WIRE
"B" - RED WIRE
"C" - GREEN WIRE
GROUND WIRE EACH COIL BLACK W/WHITE STRIPE
34