Step 4 Nozzle Selection - Snow Performance Boost Cooler 210 Instructions Manual

Nozzle Number (Stamped On Side Of Nozzle)
Locate your Hyper-Sonic® water-methanol nozzles in the kit and compare the number stamped on the
side to the above chart to determine its size. Nozzle sizing is determined by horsepower (which
approximates the engine airflow) and boost (which approximates intake charge heat).
Determine your vehicle HP and boost/or no boost (N/A) and determine what size nozzle is needed for
your application using the nozzle selection chart below. If you are unsure what nozzle to run with your
given HP and boost send a email to
Forced Induction
200-400 HP
400-600 HP
600-800 HP
Naturally Aspirated
200-350 HP
350-650 HP
650-850 HP
Seal the appropriate nozzle into the nozzle holder fitting using E6000® sealant on the nozzle threads.
**The end of the nozzle with the fine mesh screen should be inserted into the nozzle holder**
**Teflon sealants are not compatible with methanol, and should not be used with the install of

Step 4 Nozzle Selection

Hyper-Sonic® Nozzle Identification Chart:
1
2
3
4
5
6
Correct
your Snow Performance Boost Cooler®**
tech@snowperformance.net
Correct
Nozzle Size
60 ML/MIN
100 ML/MIN
175 ML/MIN
225 ML/MIN
375 ML/MIN
625 ML/MIN
for assistance.
Nozzle Size
#3 175 ML/MIN
#5 375 ML/MIN
#6 625 ML/MIN
Nozzle Size
#1 60 ML/MIN
#3 175 ML/MIN
#5 375 ML/MIN
Page | 5